what should u do if?

[comptech21]

---

i recently purchase a month old motherboard......

i wasnt able to test the item directly since i was so busy.....today i got to test the item i purchase.....

the i place the psu on the table together with the motherboard and ram...and hard drive with optical drive hoping to set it up before installing it inside the casing.....when i turn on the computer...it turn on and i entered the bios setup to place the priority booting on the optical drive....and save and restart....place the installer cd in the optical drive.....den it suddenly stop.....it just turn off....

i did what a normal technician would do....take out the non-essentials.....removing the hard drive and the optical drive.....still it would turn on....after a while it would just turn off....i replace the power supply with a power supply that is being used by my other computer....hoping that this would solve the problem....but still it would turn off.....next i replace the processor....with a processor of a working computer....still it would turn off......


do u think the problem lies in the motherboard? or any ideas?

[wendellmb]

try i test ang RAMs?

[poldopunk]

you've ruled everything out, it's a dead motherboard VRM.

[freelancetech]

@TS: I've also encountered that problem and its my CPU!. Did you check the thermal if it goes higher? coz mine before would shutdown when it reaches 75C.

[juks]

most likely ang mobo ang prob. pero i check pud ang imo psu basin init ra.

[jay-em]

you never tried clearing the CMOS, or reseat the battery?

[freelancetech]

@TS: Try bios flashing update maybe it will resolve the issue. Check your manufacturer's specification of your product update.

[eXpLoDe]

what is the specs of the parts that you use? kindly post it here. thanks

[balipseyev]

Clear CMOS sa, pag dili gihapon... try to flash BIOS... Ug di jud... buy another MoBo...

[chriztophers]

Btaw, pinaka dali nga solution ani is buy a mobo.. But kung ganahan ka mag experiment try checking the mobo kung dili ba grounded basin naay mga hugaw nga naka cause ug ground.. Bisan ginagmay rana siya maka affect pud na gihapon.. Then check pud kung wa mag overheat imo procie kay mo off jud na siya once mag overheat... Then, PSU pud basin dili enough or shall i say not strong enough to run your mobo.. Probably dili stable iya current/voltage... Then, check pud basin grounded imo power switch..

Anyway, unsa psu gamit nimo bro?