3d rendering

[anito]

---

need advice kung makatabang ba ang CPU cooler pra sa rendering sa 3d, ing.render gud nako moinit pg.ayo ako procie. if it can help mopalit unta ko kay mg.kamang sa rendering ako pc. BTW Core2Quad ako processor/4 gig RAM/1Gig 256 bit VC....thanks.

[orlyboy78]

need advice kung makatabang ba ang CPU cooler pra sa rendering sa 3d, ing.render gud nako moinit pg.ayo ako procie. if it can help mopalit unta ko kay mg.kamang sa rendering ako pc. BTW Core2Quad ako processor/4 gig RAM/1Gig 256 bit VC....thanks.

how old s your hdd bro?
check dw ang cpu temp ana bro sa cmos.

[anito]

1 year ang naa OS den ako slave nga 500gig is 6 months....

[COMCAM]

How hot is your procie? might be airflow problem with your case. An after market CPU cooler fan type or the watercool type like the corsair H50 can decrease your present temperature but its no use if you have a bad airflow with your case.

Just like my Aussie friend doing space claim and autocadd at the same time with two monitors (none aircon room)- ni flicker pag ayo eyang isa ka monitor, then mu pawng eyang system - no problem with Video card, its only the airflow. I just added a 120mm fan on the 5.25 bay area as intake and two 80mm exhaust at the back.

Naturally mu pawng jud eyang system kai mu abot eyang procie temps ug 60 C as well as the VC. Now stablizes at 50.

[anito]

render time abot ug 60 ang temp sa ako procie, 3 kabuok ako fan...usahay gani tangalan nako ug side covers ako lang ibalik after use...palit n lang jud cgro ko ani ug CPU cooler, slmt bro.

[Seiryuu]

60 degreese Celsius during 100% load on a C2Q is still safe bro...but its much better if you could lower it to 50+...just a question, how long do you keep your proc at 100% load? i've done stress tests on my proc (C2D) at 100% load for about 10 hrs and it hit 60 degrees C but i've never encountered any errors...

also, pde mag-ask sa placement and type sa imo fans? airflow isn't just about the number of fans...COMCAM may be able to give you advice on that..

[centax error]

btw, what software you use?

[anito]

mura exhaust nako tanan ako fan, di lang k particular sa sizes..i have a big fan sa front and two smaller fans sa back nd sa side...

[anito]

mura exhaust nako tanan ako fan bro, di ko particular sa size basta i have a big fan sa front ug usa sa back ug usa sa side...pro usahay gani tanggalan nako ug side covers. 6 to 7 hrs ko usahay mg.render bro.

[anito]

i use 3ds Max...