Q6600 or Q8200?

[Sasori]

---

@virus247

hehe murag outdated nana imu intelburntest bro da, check the latest version here
btw nice OC, e push pana bro payter kaayo kag mobo

[virus247]

@virus247

hehe murag outdated nana imu intelburntest bro da, check the latest version here
btw nice OC, e push pana bro payter kaayo kag mobo

awz..ahaha..sayop akong napislit d.i..ang native..ahaha..suwayan pa nko bro..

nice overclock, bai. no plans on increasing vCORE or FSB further? dako pa kaayo ka headroom bai since naka low man diay to imong fan speed.

if wala na, let's proceed. you can run your memory at its rated speed by using 5:8 divider since you're now under the 333 strap, ang 1066 available na at the said ratio pero if you want to run it synchronously (1 : 1), layo-layo pa ka sa memory speed which is 533 MHz for 1066.

DDR2-1000 is only good if you're running it at CAS4, at CAS5 tabla rana DDR2-800 CAS4. yours maybe a little slower since timings are a little loose. there's a difference in performance (at least on synthetic benchmarks) when you set the memory at 1066 5-5-5-15 and moreso if you tighten the northbridge latency as well (Common Performance Level a.k.a tRD) so please take a memset screenshot.

if you're up to the challenge, make 533 MHz your front-side bus goal. this will put your FSB in sync with your memory which makes tRD a little easier to tame than using extreme ratio. 533 x 9 is highly unlikely for this chip but 3.2 GHz (533 x 6) is plausible. if you can reach these speeds, then we'll continue tightening memory and mch latency.

EDIT: (do not forget to enable advanced roundoff checking in Prime95)

- if you want to stick with your overclock right now, run a In-Place Large FFTs. this will ensure that the processor and MCH are stable. i'm sure it'll pass because you haven't done any tRD setting, yet. if this test fails; the components to blame are usually just the CPU and Northbridge so the voltage that you need to optimize to are either of the following: vCORE, MCH CORE, CPU VTT, GTL Reference Voltage.

- if it passes, proceed to a custom (blend) test, adjust the memory to use in MB. match it with the available memory on the system.

mao nani with in-Place Large FTTs

with intelburntest