pwede ni???

[je0frey]

---

ako....nani...gtry...dli...man...noun..ko...ka.int ernet..page..cannot..display..man...noon..sir

any..idea...

your dsl port is NGN right, no authentication dynamic ip lng cya? That configuration should work. But if naa ka authentication you must used pppoe encapsulation on WAN set up to input you username and password. And on ip auto lng cya, remember sa WAN set up ni cya ha not on LAN.
Then check on system status, at maintenance tab, your wan should have ip address if you have set up correctly. If WAN is ok but still can't internet check on NAT it should be SUA so your private ip's will be NATed to you internet ip, the default there is none. Also your DNS server, you must have valid DNS server configure on LAN setup of your modem.

[JemjunXpress]

i...know...brod...na..if..im..using...router...mo. ..run...gyud....akong..nahibaw.an....nga...router. ..econfigure....kai..linklys..raman....

nop! poidi sad sa router na netgear!

im using now modem ZyXel P-600, and router dual WAN Netgear (Model FVS124G)

try set-up again or searching google

[mazkot]

As i said and someone already said P600 is a modem.

Tip lng bro:
Never Treat all technical problems are the same. k imo hi treat na pareho ang hardware nimo sa una nimo hi setup na pareho sa imo hi setup karun.

It just a simple analysis and common sense just first look at what was different. Since kita ka na lahi ang model then do your research.


so buy any brand of router. read the manual on how to setup it up halos pareho da na sila linksys dlink ug cdr king..

unless you prefer to be spoon fed.

[je0frey]

if you still find it difficult to configure may be these would help...

ON WAN SET UP:
http://i410.photobucket.com/albums/p.../routinghq.png

ON LAN SET UP:
http://i410.photobucket.com/albums/p...frey/lanrb.png
http://i410.photobucket.com/albums/p...0frey/dhcp.png
on DNS server you can use 203.172.11.21 and 25, or better just copy what you are using right now..

ON NAT SET UP:
http://i410.photobucket.com/albums/p...e0frey/nat.png

Note:
After this you have to apply, save and restart the modem, cause sometimes the changes wont automatically apply.
Also reset the tcp/ip of your pc to dynamic after all are done...

[moy2]

pwde kaau but overkill nsd kaau if mag 2 hub pka.just use 1hub.or try modem to router n switch hub.it works.lolz.

[junielromares]

if you still find it difficult to configure may be these would help...

ON WAN SET UP:
http://i410.photobucket.com/albums/p.../routinghq.png

ON LAN SET UP:
http://i410.photobucket.com/albums/p...frey/lanrb.png
http://i410.photobucket.com/albums/p...0frey/dhcp.png
on DNS server you can use 203.172.11.21 and 25, or better just copy what you are using right now..

ON NAT SET UP:
http://i410.photobucket.com/albums/p...e0frey/nat.png

Note:
After this you have to apply, save and restart the modem, cause sometimes the changes wont automatically apply.
Also reset the tcp/ip of your pc to dynamic after all are done...

bro.. salamat kaayo... pro.. dili man ta parihas ug modem!!! parihas mo ug modem sa katong first nakong gsetup...nya ni ran......

palit lang cguro ko ug modem!!

again thanksss u

[bokang]

if modem-router ang gprovide ni pldt, pwede na imo set-up. ug pero kng 2 PCs ra, usually 4 ports na ang modem-router so d nka nahanglan switch...

[Htennek]

pag modem->router->PCS nalang.

[junielromares]

salamat sa inyong tanan....

okey na.. n palit nako ug router....

again thank sa inyong help

[thelo]

mga master mo run ni

pldt modem ------->switch 8 ports---------->2 pc


pls help,,,, tabang!!!!


thank u daan!!

very possible refer to this link for guidlines. the cables and ports should fit 100%. if it won't fit on the port on the device, then it's not there. hope this helps enjoy!