try sa mga surplus shop bro.. basin naa ka madawdaw ngadto.. same sad na sa akoa imo problema bro pero wla pa ko naka thorough test jud...
try sa mga surplus shop bro.. basin naa ka madawdaw ngadto.. same sad na sa akoa imo problema bro pero wla pa ko naka thorough test jud...
heres what you do..ONE STEP AT A TIME.
its a process of case investigation thru data analysis and deduction
have a pen and paper ( for checklist ) first and foremost..KNOW UR MOBO.. onboard ba ang video | non onboard ba
1. remove the components from the cpu
2. assemble the mobo.PROC. and PSU ( in a well lighted table , wa walay samokan, para ka concentrate ka ).
>> connect a swith button and reset button. NO VC AND RAM. : if non onboard ang vc
>> if onboard ang vc, connect a monitor sa vga display port
>> CONNECT A PCI PC ANALIZER
3. remove the CMOS BATT. put a newly purchased one ( many times this is the culprit )
4. TURN IT ON!
>> longggggg beeeppppp? yes : ram error << replace ram
no : lets continue
: beep beep beep? YES ( non onboard only ) vc error >> replace it with a new one * reason = if naa vc installed , it won beep beep beep..since the agp port cicuitry is filled up.. di lang mu work.
: beep beep beep? YES ( on board VC ) mobo MCH error. buy new mobo
: beep beep beep? no? the mobo is candidate for replacement, more test will confirm it.
>> Analizer reading ? code no.. refer to the manual
5. turn off. ADD MEMORY ( non onboard vc )
>> TURN ON.. Loongggg beeepppp = no memory module detected.. : replace memory, continue test
Loongggg beeepppp gihapon. = no memory module detected. check memory slot..check for PUTOL | Burned connector
no bep at all ( and you know working ur memory, mobo is candidate to be confined sa greenvalley, test it some more )
if ok na ang memory , mu beep gyud ni ug.
beep beep beep : YES! now u got it.. replace with a working VC ( PCI-E or AGP. depends on ur mobo )
beep beep beep still: remove vc, check vc sot properly, basin naputlan ug contact point.. put OLDIE PCI VC ( maski 1mb lang : that y its gud to keep 1 if mag ayo ka ug pc )
beep beep beep : ILISI NA ANG MOBO
if VC or VC slot ra ang guba. mu beep | booth na gyud ni
>> unsay reading sa PC ANALIZER?
na brown-outan. posible damage by Power Outrage..kana black chip with 3 points duol sa power sa proc slot ur memory slot.
based on experience ni.
Last edited by butitoy; 05-01-2009 at 01:01 AM.
@butitoy, salamat kaayo bro, ill do this once mabalik na nako akong PC,kay akong gipatestingan sa akong amigo kung mo work ba sa iyang PC ang mga components like RAM and VC. kay kung mo work ni atleast mobo nalang ug processor akong testingan base sa imong troubleshooting tips.
probably mobo nmo bsta ing.ana.but if mo display xa aw dli sa imu mobo oi.bsn pod sa imu proccessor.pru panagsa rmn ma guba ang proccessor oi.pru depende.try lng 2 isolate bro.![]()
trial and error...pero feel nako proc/mobo ni nga issue...
grounded lng ana or damage na ang board nimo,,,,,,
gisuwayan n b nimo'g tanggal ang processor?
murag mobo jud,aky ako na gisulayan tanan, dili man gyapon siya mo boot/beep, huwat sa ko sweldo para palit ug bag-o board kay wala jud koy kahulaman diri,hehe
Similar Threads |
|