is this cpu cooler good enough for my needs?

[fish]

---

i already bought and installed my gigabyte g-power cpu cooler. i got the P1,700 version, and i have it running at 2,000rpm. looks good with the lights, and my temps are lowered a little bit. its noise is bearable. mejo gatapot na ang cpu cooler fan sa ako power supply.

and your temps?

[whoopz]

at start up ga 33c. i leave it for an hour nga idle, ga maintain cya 36c. but if i play r6 vegas, it climbs to 48c. after playing r6 vegas, mu lower cya to 45c.. and it takes quite a long time for it to get back down to 39c.

[fish]

at start up ga 33c. i leave it for an hour nga idle, ga maintain cya 36c. but if i play r6 vegas, it climbs to 48c. after playing r6 vegas, mu lower cya to 45c.. and it takes quite a long time for it to get back down to 39c.

unsay specs ani imo system bro? and overclocked ba ni or not...

[whoopz]

@fish,

ako specs bro kai mao ni:

c2d e6300 oced to 2.3ghz (want to go at least 2.5ghz pero unstable na cya above 2.3ghz) gigabyte g-power bl cooler
msi p965neo-f
2gig ddr2 800 ram (2pcs geil 1gig value)
palit 8800gts 320mb
160gig seagate sata2 hdd
lite-on dvd rw sata
hec winpower 550watts


about my temps, dili cya consistent, mag depend pud sa panahon, if mag ulan mejo lower, if init pud panahon musaka pud gamay.
but sa ako estimate lang mga 3degrees lower ako temp with this new cooler compared to stock.

[spookey]

ahh... nagOC diay ka. nagwonder man gud ko ngano medyo taas gamay imo temp. ok ra man siguro na bro.
mine is C2D e6600 at stock settings and stock cooler. idle at 30-32c and load at 40-42c.

[whoopz]

my casing lacks a little bit of air output plus naa ko 12inch nga neon light inside. ako fans ky 2pcs intake in front and one output fan at the back all 80mm. side panel is modified with real glass.

im ordering another case nga generic ra but has 120mm fans: in front, at the back, side, top. i hope this will help in lowering my temps becoz i think my current case is inadequate in blowing out the hot air.

[fish]

@fish,

ako specs bro kai mao ni:

c2d e6300 oced to 2.3ghz (want to go at least 2.5ghz pero unstable na cya above 2.3ghz) gigabyte g-power bl cooler
msi p965neo-f
2gig ddr2 800 ram (2pcs geil 1gig value)
palit 8800gts 320mb
160gig seagate sata2 hdd
lite-on dvd rw sata
hec winpower 550watts


about my temps, dili cya consistent, mag depend pud sa panahon, if mag ulan mejo lower, if init pud panahon musaka pud gamay.
but sa ako estimate lang mga 3degrees lower ako temp with this new cooler compared to stock.

ha? E6600 nga 2400 ra taman? murag tungod tingali na sa imong mobo bro... sulayi ug lower ang multiplier, then increase your fsb. i-relax sad ang timings sa imong memory, and set a memory divider ug lower frequencies.

[whoopz]

@fish, yup diha rajudko taman sa 2.3ghz bro. ako vcore cannot be increased ky wala ni nga option sa ako mobo, but even then, sa reviews ako nabasa sa e6300 it can easily reach 2.8ghz daw without increasing the vcore. dont know whats really wrong with my setup. kennruss has the same setup as mine, and oced in the same way, but maka reach daw cya 2.6ghz, nya ako dili.

[emoners]

it's because of the mobo bro...MSI is not an overclocking board.

[fish]

@fish, yup diha rajudko taman sa 2.3ghz bro. ako vcore cannot be increased ky wala ni nga option sa ako mobo, but even then, sa reviews ako nabasa sa e6300 it can easily reach 2.8ghz daw without increasing the vcore. dont know whats really wrong with my setup. kennruss has the same setup as mine, and oced in the same way, but maka reach daw cya 2.6ghz, nya ako dili.

sayang... palit nalang ug bag-ong mobo bro. hehehe!

@emoners. depende ra man tingali bro, kay ang akong K8N Platinum sa una, daghan man kaayo to ug options... di ba imong Diamond is an overclocking board...? di ba daghan man to ug options ang diamond for overclocking...? its bios was even compared to a DFI board.