Ocing q6600 with asus p5qd turbo

[archspace]

---

ah okay. tnx. ako na i try. ddr2 800 man ako settings ka ron.

[keropi]

fsb-memory ratio iyang pasabot bro. If im not mistaken, you had it set to "unlinked" meaning dilil mosaka anf mem clock along with the increase in fsb..

[archspace]

update: stress testing it now.

memory frequency at lowest ddr2725 (800 before)
cpu voltage at 1.40 (1.44 before)
aiming for 3.3 for now.
temps at 65c full load

i will try to lower voltage if okay ni and no bsod.

[werty]

try intel burn test @ max memory for burn-test, it gives me errors earlier than prime when i was overclocking before. i usually run it for 10-15mins for a quick burn-in test, then increases fsb if no errors found. and test again.

[archspace]

FAILED. upping voltage to 1.41

FAILED. sigh

okay rani ako mem timings at 5-5-5-18?? basin sayop ni. dram frequency at ddr2725 (lowest)

[werty]

post daw cpu-z screenshots sa tanan niya tabs. ato tanawon.

kung makaya nmo, post pud ang bios settings na imo mga na adjust so far.

[archspace]

dunno how to capture sa bios but mao ni ang settings jd. g copy ra nko manually.

ai overclock tuner manual
cpu ratio setting auto
fsb frequency 367
pcie frequency 100
dram frequency ddr2 725

cpu voltage 1.4
cpu gtl reference auto (should i touch this?)
cpu pll voltage 1.5 (not sure)
fsb termination voltage 1.32 (not sure)
dram voltage 2.1 (not sure)
nb voltage auto (shoudl i make adjustments on this?)
sb voltage auto (shoudl i make adjustments on this?)
pcie sata voltage auto (shoudl i make adjustments on this?)

spd

[werty]

apila spd tab aron naa mi idea about sa imo memory

PS:

BOOM! dili pareha ug memory hehehe. try to manual set imo RAM timings. sunda na ang value sa imo Kingston jedec #3 daw. or u can try overclocking with only 1 memory-use kingston kay CAS6 sya

[archspace]

try nko.. haha ni mention naman ko dli rehas ako mem

UPDATE:
testing now with 6-6-6-18 mem timings
cpu voltage 1.41
temp 65c
aiming 3.3 oc