Where did I go wrong?

[HasseJ]

---

I just installed the H60 today using Coolermaster thermal compound...I have temp issues guys, its running around 70-80c @ IDLE, sometimes rises up 90++++

Just to say airflow in the case is good I even leave it Side panel OPEN, airconditioned sad ako room below 25c temp..




my specs we're
i7 3770 w/ h60
h77
8b ram
1gb discrete vcard
600w modular psu
1tb hdd
27" monitor

I think i've connectd pins right.. do i need to re apply the thermal? Unsa man dapat e check ani

[bitag]

inita ana...check pump & fan cable basin wala nataod or wala nataod tarong,or putol ba ron,basin wala pod nagsupply power into pump...or wala nataod tarong ang cooler,wala nitouch ang copper/cooler sa cpu.

[renaire33]

-Check if pump is still ok
-reseat h60
-basin naay bubbles sa imong H60 block, shake daan before reseat
-reapply thermal paste

[MarXX]

i have a stupid question, did u remove the plastic cover of the copper plate?

[butitoy]

i have a stupid question, did u remove the plastic cover of the copper plate?

hopefully not : oh seet. i forgot.

hehehe

good question MarXX

[Wadexx]

Atimana dayon na boss, ayaw na paabot nga mausab rag iya ang temp. Pa-ig agi ana.

rule of thumb ha, opposite sides ang pag pa huot sa screws. top left, bottom right, top right, bottom left. para maka lingkod ug tarong ang block.

[HasseJ]

i have a stupid question, did u remove the plastic cover of the copper plate?

hehe pre-loved ang h60 so na used nani xa wala na plastic cover.. if had so, obvious man siguro, impossible sad defective ky bag o rani nako ge pull out gikan sa previous set up where it was working fine 30-40s ra TEMP...

What I had done so far

• Re-applied thermal paste
• Tried adding another 120mm fan for Push & Pull
• Ex-change the connecting pins (PUMP & FAN) to see if one might be defective, but both were fine coz fans are working
• Also tried shaking as what you'd guys suggest, I can hear it..

How can i tell if bad ang contact sa coper to procie cause when i pull it out, na scattered man pud thoroughly ang thermal.. meaning na COMPRESS ra xa og tarong.. and yes up-right, down-left, up-left, down-right aq pag screw

Inani porma... sory sa paint

[psychyze]

Dili kaha ang position sa block?
http://cdn.overclock.net/2/2a/350x70...installed.jpeg

[HasseJ]

Dili kaha ang position sa block?
http://cdn.overclock.net/2/2a/350x70...installed.jpeg

di man siguro kay kita man sad ko same og position sa akoa sa google.. like this:
https://www.techenclave.com/communit...043-jpg.23349/

mosango man gud sako rams if dili nako ipababaw ang hose

[mike_aizen]

di man siguro kay kita man sad ko same og position sa akoa sa google.. like this:
https://www.techenclave.com/communit...043-jpg.23349/

mosango man gud sako rams if dili nako ipababaw ang hose

check basin na overtighten nimo ang screws mounting the cpu block to the CPU....