PUSH PULL sa RADIATOR Inquiry

[vanz_paltog]

---

unsay mas maau buhaton ani akong radiator...

ang rad fan is nka.set nga mu.pull ug hangin gkan sa case padung gawas sa case...

gusto ko mag.butang ug push para nindut tan.awn and mas ubos2 daw ug TEMPS...

ako pangutana kai... kinanglan ba pareho ug fan ang akong ibutang ?


for.reference lng ni sa akong set.up rn..

[LordZhen]

PUSH PULL configuration doesnt have any temps difference or whatsover from push or pull, same sa push or pull no difference on temps. Nindot siya tan-awn but no difference on temps. If mag push pull ka pde raman dili same ug fan speed

Refer to this video about push/pull and push and pull

[vanz_paltog]

salamat @LordZhen ... dili man ko mka.stream vid dri boss.. kai hinay man kaau amung net dri hahaha


as is nlng jud ni nako ang rad ug fan salamat

[kaotep]

no difference in temps but you will have increased airflow meaning the rate of temperature decrease is higher. mas paspas munaog ang imong temps.

[werty]

dungag2 lang na sa saba addn't fan. unneccesary lang sya kai within safe temps ra gihapon ka way reason to lower temp as much as u can if stock setting man lang imo procie.

[LordZhen]

dungag2 lang na sa saba addn't fan. unneccesary lang sya kai within safe temps ra gihapon ka way reason to lower temp as much as u can if stock setting man lang imo procie.

correct, specially you are not overlocking or your procie is the non "K" variant

[Sempron Guy]

experiment sa positioning sa rad. Try it as intake it first tapos exhaust na dako nga fan sa ibabaw or himoa nang exhaust ang rad fan tapos intake fan ang ibabaw. See what works for you.

[butitoy]

putting it pull is a much better position

PULL : HOT air is suck from the radiator then goes out of the other side of the fan then to the exhaust vent in millimeter distance


PUSH configuration have higher volume of backflow air since the radiator is a grill and not an empty hole.

[gaspar_73]

useless gihapon mag push-pull...hinoon choy tan-awn...in sa uso..

[LordZhen]

no difference in temps but you will have increased airflow meaning the rate of temperature decrease is higher. mas paspas munaog ang imong temps.

i totally disagree with this, i have 3 radiators on my rig, i tested the push pull and pull or push config, wala juy nakalahi sa temperature even on the rate na mo decrease ang temp will be higher. (kay overclocker man ko), using the same fan for the same speed of rpm during the test.

Just like what linus said on the video, we can discuss it all day until the cows come home, there's no difference, and its already proven countless times