sa mga gusto mo rewind sa ilang mga stator, kani ako ika share... sa wave 100 ni nga stator..
ako ni g rewind kay naa scratch ang original coil wire nya gusto sd nako e convert to full dc ako system basin naa na budget for HID in the near future..hehe.. this is intended for a fullwave system&full dc...
magnetic wire is AWG#18..70 turns per pole... You can always use bigger wires like AWG#16 for more
current output.. lisod lng kaau e wind kay gahi nman..
yet to make fullwave regulator rectifier for this stator.. that my next project..
didto diay ko nka palit magnetic wire sa V Gullas street luyo gaisano main.. makit rman dayon na mga
spool sa wire nga ila baligya.. worth around P200 rman ni nga wire then naa pa subra...
[IMG]

[/IMG]
hehehe..sorry kay sa luyo sa resibo ni pilit ang schematic diagram
[IMG]

[/IMG]
[IMG]

[/IMG]
[IMG]

[/IMG]
make sure na maau pgka arrange ang wire pra dli mo bulky ug maau imo winding..
[IMG]

[/IMG]
use diay tape to secure the winding kng mo hunong mo pra dli mo luag..nya e tape sd na mga sharp edges pra iwas scratch sa wire while winding...
[IMG]

[/IMG]
[IMG]

[/IMG]
ayaw diay kalimot ug alternate sa winding direction.. clockwise-counterclockwise-clockwise and so on...
OR CCW-CW-CCW either ways basta alternate... pra dli ma cancel out ang output..
ako pani e epoxy or e varnish(electrical insulation varnish) pra ma secure ang winding then e solder ang mga wires sa lugs...
hope you like this...