Replacing Satellite/rear speakers

[ishzhi]

---

mga boss, ask lang ko, naa koy altec lansing dri 4.1 mejo karaan na nga model, nya murag hinay nman ang tingog sa mga satellite speakers, pwde ba lain brand nga satellite speakers i butang? mu affect ba na siya sa overall quality?

thnx kaau

[Vino Kid]

seguro atp5 na imo antec lansing..

ok ra man seguro basta same specifications lang or known brand sat speakers...

basin grabe ka momalmal ana imo speaker, pakusgan bahalag mokarat na....

[mE_bytes]

boss, try daw check if wala ba nagisi imo sat speakers.,
try to check if naa busted caps imo amp., maka-cause sad siya muhinay ang output.

if magreplace ka sat., make sure pareha sila ug impedance sa orig sat sa replacement sad para dili maguba imuha amp.

[ishzhi]

tnx kaau sa inyu mga replies, anyways wala man sad gi malmal hihi dugay nlang jud wa na gamit balik, and about sa impedance, unsa diay na boss? no idea jud sorry, pero mao ni ang specs sa satellite:

SatellitesSpeakers (per satellite)
One 3 inch(75mm)
Audio Power 5 Watts perchannel(20 watts total)
Frequency Response250 Hz – 18 kHz
S/N Ratio>65 dB

asa diri dapat nako i pareha if incase mu palit ko lain satellite boss? or pwde ba kanang regular speakers lang sa pc kanang walay subwoofer, i thnk stereo speakers tawag ana, then gamitan lang nako ug adaptor ang mga jacks niya, pwde ba?

salamat jud kaau sa inyu tabang

[mE_bytes]

kailangan sad ka makahibaw sa impedance bro., usually nakatatak na siya sa magnet sa speakers at the back.

Why are ohms important?
Two reasons:
(1) If you connect your amplifier to the wrong speaker impedance, you risk damaging the amp. In tube amps, too high a load impedance (or a disconnected load) can result in damage to the output tubes or output transformer, while in solid state amps, if the speaker impedance is too low, the amplifier will tend to overheat and more power is used up in the amplifier than is delivered to the speaker. Too many speakers on a solid state amp can burn up the power output section.
(2) The amplifier will deliver maximum power (volume) to the speaker when the speaker impedance matches (is equal to) the internal impedance (called the OUTPUT IMPEDANCE) of the amplifier. Too low an impedance will result in weak output and poor tone. If the speaker impedance is higher than that of the amplifier, its power output will again be less than it is capable of.

source: Speaker Impedance Explained - Ohms