how do i connect without a jumper?
coz the jumper from the master hdd is connected to my cd-rw
how do i connect without a jumper?
coz the jumper from the master hdd is connected to my cd-rw
umm i.remove nko ang pin na nka connect sa cd-rw?
then mao ako i.connect pra sa slave na hdd?
senxa na newbie at this ^_^
hmm... slavery was abolished more than 150 years ago... j/k.
on topic:
unless you're good with electronics... pin 28, grounding, soldering...
you're better off buying/stealing/begging for that jumper... because there's no way you can make that HDD a slave w/o the jumper.
Last edited by coolnezz; 05-21-2009 at 07:19 PM.
umm naa koi laen hard disk den nahan tah koh i.slave xa
then pag chek nko sa cpu kay ang jumper nka konek sa board to hdd to cd-rw
i'm assuming you're using IDE drives... two HDD and one CD-RW
your motherboard should have two IDE controllers.
on your 1st IDE controller, you can connect the two HDDs. Master HDD should have the jumper, the slave HDD don't need the jumper.
on your 2nd IDE controller, you can connect your CD-RW, no need for a jumper if connected as single drive.
obviously you need another 40 or 80 pin interface connector cable for the 2nd IDE controller.
sata na lgi ta wa pai jumper2 and wat so ever pas2 pa ang data nya.haaay.![]()
Similar Threads |
|