CISS for Epson T10 2.5K FREE install & delivery

[gabs]

---

Really Big Savings jud nga guys. Ive been using this for over a year na and now decided to sell it here

Just Arrived March 24, 2009 10 pcs of Brand New Continuous Ink Supply System for EPSON T10 with 100ml ink per color (magenta, cyan, yellow, black)

2.3K Only(REPRICED) and FREE INSTALL AND DELIVERY(Mandaue City)

with 1 month personal warranty

Location: Near Hi-way Maguikay Flyover Mandaue Below "Dating Daan Headquarter" beside Goldilocks

Also Available 100ml refill ink bottle for 100 pesos only per color

thousands of full page print ang maproduce aning free nga ink, layo ra jud if mopalit ka ug cartridge2x

and speaking of print quality, di jud halata ang kalainan sa orig. more than 90% imo ma save.

Contact: PM me or 09079962092.







sample



BUY NOW!

4 units left!

[darkdruid]

based on the picture.. is that the way how you really install thouse CISS?

up for now...

[gabs]

@ darkdruid, thanks. mao man jud na. y man?

[Lunch]

mosangko na ang tubing sa bottom part sa printer inag kadugay. moungot na ang part nga nag-move sa printer. i post pic kung how we did it to avoid the problem.

[Lunch]

pic above shows how to manuever the tubing so that from the head, the tubing goes back up instead of going down

picture below shows good clearance from the tubing to the bottom of the printer; this will prevent the tubing from being stuck when the head moves back and forth.



i can guarantee that this works based on experience.

i've also "rescued" a couple of printers that had the tubing held by masking tape; this is very Wrong.

I hope this helps.

[gabs]

@lunch thanks for the info.

actually kana u demonstration is ok man coz in ana man amo paginstall sa amo printers before ako lang

giusab coz mas masara man ug tarong ang cover if paubos ang tube. for the sake mas presentable to

look at. i am not also using any masking tape or any tape kay hugaw tan awon as shown in my picture

posted.

[gabs]

regarding sa mosangko nga tubing diay, di na kasangko kay layo ra jud kaayo ang tubing sa moving printing

head. Tested na ni siya coz dugay na mi nagamit ani

[Lunch]

@gabs, it's not the tubing outside that i'm talking about. . . that's ok to put it up or down.

look at my first picture (the one on top). from the cartridges, it goes down, and goes back up again. . . this is so that the tubing will not hit the floor of the printer (look at the second picture kanang puti, that's the floor i'm talking about).

if you don't do this, it will not hit the floor dayon dayon but eventually it will hit the floor and the side of the moving part that's holding the cartridge and makaungot na siya.

[gabs]

up up guys

[gabs]

up for this evening