HP Deskjet D1460 problems!

[Motownkid]

---

i bought this printer last month at HP SM Branch & medyo karon ra kaayo nako nagamit coz i have to print some important stuff. makasapot lagi ni sya ay coz everytime i click "PRINT" daghan kaayo ug arte ang printer!!!

-usahay no reaction ang printer after i click "PRINT"
-then i have to turn it off & on again
-pirmi pod mag warn "PAPER JAM DETECTED" but actually wala gyuy paper jam
-it takes me several minutes pa before ko maka-print ug one single page!!!
-then kung mo-print na gani, dili pa jud magka-dima-o, usahay mag-balik² ang i-print.
-dghan pa jud kaau mo-pop up everytime i turn my computer on like "HP Online Registration" blah3x!

abi nako mo sit-&-relax ra ko ani nga printer, click² lang then it'll take care of the printing job. gi-balik² na nako ug basa ang manual & followed all its instructions pero mao ra gihapon... mahay ko maypa katong new Epson na lang ako gipalit kay pang-masa ra kaayo, very user friendly...

Pls help unsay ika-tambag ninyo aning piece of sh!t nga printer nako!!! thanks..




mods please merge if similar thread already exists, thanks.

[luwid]

ahhmmm ..diko sure pero kasuway ko ani nga problima.. palitan ra nako ug orig bag o nga cartridge..

[Motownkid]

yup nipalit ko ug new cartridge the other day bro didto sa HP Northwing.. pero mao ra man gihapon oi.. same old problem.. maka-sapot na lagi kaayo!

nka-try pod ko ask sa personnel nila before.. pero wa may klaro ka-storya oi mura mag mga adik..

[luwid]

try kuno na install sa lain pc bro para ma isolate ..kung ang printer mao ba dyud ang naay problema..

[grooxe_forever]

Try isolete bro uninstall the driver then i unplug sa ang usb port. Power on the printer so be sure nga dili mo blink blink ang LED dapat steady lang sya, meaning kung naka steady mode ang LED ready siya no problem. But kung mag blink blink there something error siya. Try open the printer door kun mudagan ba sa center ang cartridge carriage, then ibalik napud nimo ug close kun mudagan nasad siya sa daplin inig close. If mag blink blink gyud ang LED try replace cartridge basin guba ang circuit, no matter Original or refilled nga cartridge basta ok ra ang circuit. If dili mag blink blink ang LED try plug the USB port then observe if the printer being detected or mo found new hardware siya, then put installer CD in CD drive then next next dayon para dali ra ang installation. Ayaw agi sa didto sa Add New printer dugay man gud na siya. Para dali ipadetect nimo ang printer then once found new hardware na gani i load nimo dayon imong installer. TRY this Hope this will help...

[BroadBandAC]

i bought this printer last month at HP SM Branch & medyo karon ra kaayo nako nagamit coz i have to print some important stuff. makasapot lagi ni sya ay coz everytime i click "PRINT" daghan kaayo ug arte ang printer!!!

abi nako mo sit-&-relax ra ko ani nga printer, click² lang then it'll take care of the printing job. gi-balik² na nako ug basa ang manual & followed all its instructions pero mao ra gihapon... mahay ko maypa katong new Epson na lang ako gipalit kay pang-masa ra kaayo, very user friendly...

Pls help unsay ika-tambag ninyo aning piece of sh!t nga printer nako!!! thanks..




mods please merge if similar thread already exists, thanks.

-usahay no reaction ang printer after i click "PRINT"
-then i have to turn it off & on again

sometimes ingon ani ang printer once naa ka gi print na previous document na wala daun ni print then imo daun gi halt.. nag process paman ang printer ana... so printing another document will cause no reaction.... suggestion is a thorough shutdown of both printer and PC then restart... shutdown jud nimo ang pc kay nag hold paman na ug temporary command gkan sa user, bisag i on nimo balik ang printer lang d japon na ma fix...

-pirmi pod mag warn "PAPER JAM DETECTED" but actually wala gyuy paper jam

this is an intermittent paper jam failure... usually, ingon ani ang failure if nipis nalang ang papel naa sa paper feeder... mas maayo if baga2 ang nakadeposit na papel kay para ineg feed sa papel naa mubangil gamay sa last edge sa paper...

Ang maka cause jud anang paper jam is kato opto-isolator na naa sa system board sa printer na i switch on during paper feed and switch off during paper eject... if dle ka after sa warranty bro, try opening sa printer, pangitaa ang system board (most printers has only 2 PCBs, 1 for the system board located at the back and 1 for the carrier circuit which connect the cartridge and system board), then pangitaa ang opto-isolator.. most inkjet type printer kay naa spring ang opto-isolator.. if you want, post a pics of your system board then i will teach u which is the opto-isolator... opto-isolator man jud na maka cause sa paper jam...

-it takes me several minutes pa before ko maka-print ug one single page!!!

naa chance na gubaon imo printer system board causing a poor communication with your pc... USB 2.0 imo gamit?

-then kung mo-print na gani, dili pa jud magka-dima-o, usahay mag-balik² ang i-print.

like I said, possible ni command ka ug print tapos wa mu print then imo daun gi off ang printer then on nasad then print nasad ka same document.. basically, kato imo gi print at first is ma pending to xa... naghuwat to mubalik ug on imo printer kay gi halt man nimo kay dugay gud... pag ka on balik i print to niya ang pending, then i print na sad to niya kato nxt nimo gipa print...
better ana, if mag off ka sa printer, double-click lang nimo ang printer icon sa disktray then wait na mu display ang printing window... kato mga previous nimo gipa print, ipang right-click to then cancel... if tanan na na cancel, turn on the printer..

-dghan pa jud kaau mo-pop up everytime i turn my computer on like "HP Online Registration" blah3x!

99% sure ko bro na installation error.. nganu? wa man cguro nimo gi customize ang installation... click na click raman ka... during installation, naa man na mga option na u have to uncheck those stuff na dle nimo gusto naa like online updates, etc....

Better re-installing the driver and support kit bro....



I hope this novel helps.... hekhekhek.... ^_^ peace!!!

[Motownkid]

@grooxe & BroadBand :

ok salamat mga bro.. will try your suggestions pag dili na busy.. salamat kaau.

[BroadBandAC]

nope bro.... update lang dre kung unsa man gani...

[nissanss]

i had a similar experience w/ a hp scanjet 2400 (? not sure now). it was a friend's. jam error always. i brought it home w/ me, cleaned it up w/ vacuum & hooked up to my computer. i hated the cd installation. it installed a lot of apps i didn't care about. took a long time. but in the end, all was good. it worked. it printed. going back to my friend's place, jam error again! uninstalled everything & reinstalled again. didn't i say i hated the installation? u can't get to choose what u want installed. it installs everything on its own! no custom install, geez hp! anyways, after all that, half day later, guess what? jam error w/ no jammed paper on site. since it worked on my computer all i said was - not compatible w/ ur computer. it wasn't even an old computer setup.

[doreen31987]

heeyah! guys! hey motown, since in warranty paman ka why not call hp suuport?? hehehe naa ra sa teletech cebu.. hehehe.. lols... naa dha ang support sa asia pacific.. hehehe... wave3 and ga support sa southeast asia.. weeeh..... sakto suggestion ni broadbnadac... about sa installation hehehehe... pwede pud e disable nalang ng sa startup hehehe...weeeeh!