PC Problem: Won't display even on BIOS

[istorya_19]

Hello, mga ka braders.

Nag ilis ko ug RAM (gikan kang amd_intel). pero naa sad ko existing RAM na 4GB. ingon ani ang nahitabo. Pag butang nako sa bag.o na ram. everything was working fine. gi gamit2x pa nako. testing2x etc.

the nightmare started pag shutdown nako. ni pahuway sa ko kadyot (maybe mga 1 hour). pag on nako
balik sa akong PC, ni hang siya pag human jud ug boot. so akong gi hard reset. ni ok siya kadyot pero taod2x (maybe mga less than 5 mins of usage) ni palong lang siya ug kalit. ni continue ni siya na cycle a couple of times. nag memtest ko just to make sure na dili ang mga ram. 2 passes, ok ra man. akong gipang reseat ang mga
ram pero mu pawong jud siya. so nag process of elimination ko. removed my VC (R7 260x). suwayan lang on board. ok siya. nag stress test pud ko sa processor (core i3 3220) using prime 95. mga 15 mins. wa ra man ma
unsa. gi balik ang video card. ako pud gi stress test, ok ra gihapon. now pag balik na nako tanan, wa na nuon ni post. bisan unsaon nako ug reseat sa ram, di jud mu post. gi eraser trick na nako ang duha ka ram (4Gb x 2 diay), wa jud gihapon. so tang2x nasad ko tanan. Processor, RAM, and using on board video lang, di jud gihapon siya mu post bisan sa BIOS.

unsa kaha ang naguba ani?

any inputs would help.

Thank you!!

[gaspar_73]

remove cmos battery for 10min. then ibalik taud ang battery..try booting with minimal parts..listen for beep codes coming out ..inanay lang ug balik taud mga parts then test...

[techsuppunli]

hasula diay bro no..did you check your PSU?

[istorya_19]

remove cmos battery for 10min. then ibalik taud ang battery..try booting with minimal parts..listen for beep codes coming out ..inanay lang ug balik taud mga parts then test...

ako nya ni suwayan boss. salamat sa advice.

hasula diay bro no..did you check your PSU?

wa diay nako ma mention. naa ko lain back up PSU pero same ra gihapon.

[werty]

isolate mobo issue.. test outside casing. replace cmos batt if necessary. put into "reset" jumper mode 10 mins

[wylliexhan]

Clarify lang nako TS, pagpalit nimo ni amd_intel 1pc. 4GB RAM or 2x4GB RAM? Naa ka existing 4GB nga RAM then gpun-an lang nimo og another 4GB mao ni palit ka? Or 2x4GB jd pag palit nimo nya? Are the RAM's have the same Brand and Frequency Speed?

Remember, mixing memory chips may sometimes caused system not to boot normally or frequent restart will happen if dli nimo i manually set ilang timing sa BIOS. Did you try manually changing the RAM timings in the BIOS? Did you try resetting the BIOS to default settings?

Unsa diay imong Mobo TS and how many memory slots? Did you try installing 1 RAM only? Is the issue the same with 1 RAM? Did you try swapping the RAM's in different memory slots?

[istorya_19]

isolate mobo issue.. test outside casing. replace cmos batt if necessary. put into "reset" jumper mode 10 mins

tried this pero wa gihapon.

Clarify lang nako TS, pagpalit nimo ni amd_intel 1pc. 4GB RAM or 2x4GB RAM? Naa ka existing 4GB nga RAM then gpun-an lang nimo og another 4GB mao ni palit ka? Or 2x4GB jd pag palit nimo nya? Are the RAM's have the same Brand and Frequency Speed?

Remember, mixing memory chips may sometimes caused system not to boot normally or frequent restart will happen if dli nimo i manually set ilang timing sa BIOS. Did you try manually changing the RAM timings in the BIOS? Did you try resetting the BIOS to default settings?

Unsa diay imong Mobo TS and how many memory slots? Did you try installing 1 RAM only? Is the issue the same with 1 RAM? Did you try swapping the RAM's in different memory slots?

naa ko existing na Kingston 4GB na ram. ako lang gi pun.an ug usa ka 4GB. Used to be 2x2 GB na Gskill Ripjaws. i had no issues mixing ram before. ako gi manual set ilang timings pud. ako mobo is MSI B75ma P45.

[wylliexhan]

So you mean 3 pcs. RAM na naka installed sa imong MOBO 1 existing 4GB Kingston RAM og 2x2GB na GSKILL RAM? What happens if isa ra ka RAM imo ibutang? Is it running normal? Post daw og pics sa BIOS pag manual set nimo sa timings.

[istorya_19]

3 pcs sauna. ok ra pud ug usa sauna pero karon kay wa na man jud post.

[wylliexhan]

Maybe that's the reason why, even if you manually set the timings in the BIOS, it does not guarantee you that it's gonna work, 3 RAMS with different brands has also compatibility issues, .