Gigabyte z77n wifi itx Wont Boot

[j_rotten]

---

Hi just would like to ask if naay nakaexperience with gigabyte z77n wifi itx mobo nga di jud mo-boot, mu-on tanan 2-3secs pawng then mubalik na pud and pawng na pud, ako na gipang-ilisan ug bag-o mga components ram, psu, procie, batt etc., wa gihapon mugana

kana tanan components ako gitaod sa b75 matx smoothly running, so naa jud sa mobo ang problem

ako gicheck wa mn sd bent pins, it runs about 1yr 4mos na cguro, think this is just too short for its life. this is my 2nd itx mobo, first was 1st gen gigabyte 1156 same situation ra gihapon ani nga problem but nidagan to 2yrs +.

ako question naa bay nakasuway ani nga problem? is the mobo repairable? or any suggestions to this board b4 going to trash...

naa ko nabasahan sa mga forums, somewhat same problem with this, no choice junk jud,
but para sa ako anugon mn, so make the last resort na lng jd kung mada pa thanks

[LordZhen]

Hi just would like to ask if naay nakaexperience with gigabyte z77n wifi itx mobo nga di jud mo-boot, mu-on tanan 2-3secs pawng then mubalik na pud and pawng na pud, ako na gipang-ilisan ug bag-o mga components ram, psu, procie, batt etc., wa gihapon mugana

kana tanan components ako gitaod sa b75 matx smoothly running, so naa jud sa mobo ang problem


ako gicheck wa mn sd bent pins, it runs about 1yr 4mos na cguro, think this is just too short for its life. this is my 2nd itx mobo, first was 1st gen gigabyte 1156 same situation ra gihapon ani nga problem but nidagan to 2yrs +.

ako question naa bay nakasuway ani nga problem? is the mobo repairable? or any suggestions to this board b4 going to trash...

naa ko nabasahan sa mga forums, somewhat same problem with this, no choice junk jud,
but para sa ako anugon mn, so make the last resort na lng jd kung mada pa thanks

just sharing based on experience

ive ecnountered that problem for two of my clients and my own rig

the first was a psu problem, ok ang psu but mo pawng kalit then on and off on and off (dugay nko ni nabantayan kay mo run man ang defective na psu sa lain na set-up but eventually nasakpan ra)

the second was, naay ground problems, either from the case or from the power supply

the third experience is on my own rig, mo ground ang mobo block sa mobo causing it to turn on 1-2-3 off then on then off (dugay kaayo nako ni nasakpan, abi nako guba jud ako mobo which is a maximus v extreme) but when akong etaod ang iyang passive heatsink sa mosfets (back to stock) ok ra ang mobo mo andar ra, then ako napud itaod ang mobo block balik tanan loop, same on and off. Dugay kaayo ko nakasakop ani, nabantayan rajud nko when i noticed everytime i place back its stock heatsink, everything are working fine, so nka decide ko to put a masking tape kung asa mo touch ang mobo block and the problem was solved. Took me a month to figure it out.

[j_rotten]

just sharing based on experience

ive ecnountered that problem for two of my clients and my own rig

the first was a psu problem, ok ang psu but mo pawng kalit then on and off on and off (dugay nko ni nabantayan kay mo run man ang defective na psu sa lain na set-up but eventually nasakpan ra)

the second was, naay ground problems, either from the case or from the power supply

the third experience is on my own rig, mo ground ang mobo block sa mobo causing it to turn on 1-2-3 off then on then off (dugay kaayo nako ni nasakpan, abi nako guba jud ako mobo which is a maximus v extreme) but when akong etaod ang iyang passive heatsink sa mosfets (back to stock) ok ra ang mobo mo andar ra, then ako napud itaod ang mobo block balik tanan loop, same on and off. Dugay kaayo ko nakasakop ani, nabantayan rajud nko when i noticed everytime i place back its stock heatsink, everything are working fine, so nka decide ko to put a masking tape kung asa mo touch ang mobo block and the problem was solved. Took me a month to figure it out.

thank sa inputs boss
think 1st ug 2nd murag wa sa akoa na probz ky new case mn ako gitaoran (nakapalit ko ahat ug case, anyway trace lng sd nako kung naa lain factors that caused sa case) and ang 2 psu's gigamit running mn in my other rig w/c have no problem, gitaoran sd nko new generic psu same probz gihapon.

sa imo 3rd boss is mao pud na ako gibuhat, gibalik nako ang stock hsf (actually naka h60 ang cooler), pero mao ra jud gihapon. anyway ako itrace balik ang nahimutangan sa cooler, think naa jud sa grounded ang problem

salamat kaau boss, it gives me an idea.

[bim27142]

if di gyud bro, i think 2 years ang warranty sa gigabyte... i think ha...

[simoko]

before nimo e-junk...try kuno e-hot air preha anang naa sa mga cfone repairs btaw...mao rai akong gibuhat aning Asus P8H61-M LX3 Plus R2.0 mobo nga akong napalit as defective(kuyog 500GB HDD naa bad sectors)...naa pod ni sya 1 misalign pin pero after nako natarong di mo boot igo ra tuyok ang fan...mao tu akong gipa hot air...3 days na ning gadagan...so far so good...

[j_rotten]

if di gyud bro, i think 2 years ang warranty sa gigabyte... i think ha...

ok bro, ako itry pero nalimot ko asa ang recibo ani, ako lng sd icheck sa gigabyte

- - - Updated - - -

before nimo e-junk...try kuno e-hot air preha anang naa sa mga cfone repairs btaw...mao rai akong gibuhat aning Asus P8H61-M LX3 Plus R2.0 mobo nga akong napalit as defective(kuyog 500GB HDD naa bad sectors)...naa pod ni sya 1 misalign pin pero after nako natarong di mo boot igo ra tuyok ang fan...mao tu akong gipa hot air...3 days na ning gadagan...so far so good...

unsa imo gi-mean hot air boss ang tanan jud sa mobo or cpu socket ra? pwede ra heatgun gamiton? mga pila ka minutes estimate boss?

btw thanks sa another idea, will try it too

[simoko]

^^^ tanan gyud boss...back2back...akong gi try first using anang para sa buhok btaw...wala man mo gana...so akong gidala sa kanag tig-ayo ug cfone...less than 5min man tingali tu boss...

[Insane73]

sir naka try ko ana sa akoa mobo na z68x sir ask ko ining boot nimo, mo on imo monitor pero no signal? ha about sa imo kb and mouse mo bah? kay akoa mag sige siya restart pero wala display sa monitor and off ang kb og mouse. gdala nako sa nutech ang pc quickbuys na found out na guba ang mobo

[bitag]

basin guba power switch...try daw lain switch

[j_rotten]

basin guba power switch...try daw lain switch

yes tried another switch using vandal same lang gihapon, tried sd nko pa-on bag-o nga generic case ug branded case same ra gihapon. no luck

actually mao sd na ako first expectation naa sa switch ky na-experience pud nko before, mao to ahat ko palit new case, nidagan cya for 1 week but human nibalik na pud ang problem.