Where did I go wrong?

[simoko]

---

connect the pump to the CPU Fan headers and the radiator fan on any chassis fan headers...

[Wadexx]

hikapa daw ang block bro, ma feel nimo nag pump siya? or e shake ang rad. Saba ba siya? Or naa gargling sound?

[HasseJ]

Guys medyo ok na xa so far karon 30minutes na ga ON mao ni iya temps (30c-40c 's)
sa kani nga temp below, im not doing anything.. just a browser.. and these apps, wala na ba ko dapat ika worry ani nga numbers I'll try playing later...



What I've done:
Re-attached the backplate of the cooler in the mobo
Re-screwed the mount
Re-position the Block like most users.. Bali man to akoa previously, i think wla diri ang issue
Applied more thermal than usual....

Maybe I got a bad CPU contact..

[LadYKilleR8520]

Im thinking bad installation sa hold down plates.. try removing the block and tightening the mounting hardware, nasayop q ani sauna.. not saying nasayop ka, but it could happen..

[archt_vin]

^check what simoko suggested. kay si pump header ang dapat connected to cpu fan pin. or if naa cya dala spiltter, then mount the two (fan and pump header then connect to cpu fan pin).