need help about a pc problem

[kit_cebu]

---

@junnix - okay ra ang cpu heatsink sir...just checked lang gyud...karon rako kalugar...

@g-fox - thanks sir...i'll consider that...testingan pa lang sa nako nig ako...basin pa diay ma-jackpot-an...

@rochen - dili ram...naa koy laing ram sa working PC, okay ra nya ang ram ani, ma-gamit ra pod sa pikas...

@Eiso - akong gi-tangtang ang ram ani (so, way ram connected), wala mo-tingog...so most likely, board nani...

@boileroy - thanks...pero dili ram...

@DEMONOCIETY - murag mao gyud ni...board gyud...kay wa mo-tingog ang PC nga walay RAM naka-butang...mo-tingog man ta na dapat...not sure though...computer novice....

@franz10 - done the CMOS batt...

i've some sort of isolated the problems before posting here...hehehe


any other possible suggestions?

wala koy videocard lain gud nga ma-test...pero basin lagi kung board nani....atay...

thank you ALL for helping out............


.

[kit_cebu]

more inputs guys beh...

[Elvin]

Clean motherboard and inside case with compressed air, don't spray air at fans for too long (2 seconds will do) as this might produce current, some old motherboards don't have protection for this, then spray motherboard with penetrating oil or contact cleaner, available at most hardwares & electronic stores, avoid spraying fan bearings as it might remove grease lubricant, no need to remove motherboard or switch off PC

[boytangero]

if standby mode ang monitor, it means wla jud output gkan sa mobo. try to clean your mobo bro. check your cable. try huwam Vcard. if mugana den Vcard na lang imo paliton or pwede mobo for upgrade na lang pud. I experienced this problem but nadala ra cya ug limpyo ang mobo.