need inputs on overclocking x2 250

[tirabotski]

---

kinsa nakasuway ug oc athlon x2 250 w/ emaxx mcp61d3-icafe??how did it go??or better yet,is this board good enuf? i can't find any results sa google ky murag this is a cheap board.. sa ako ning nephew..ako lang practisan oc..

[KH0UJ]

ako bro naka testing na ko sa ako-ang regor 250

[rejiel]

ako bro naka testing na ko sa ako-ang regor 250

unsa nga board imong gamit sir? stable ni siya, murag ubos lageh imong core voltage... TIA

[tirabotski]

ngiloha ana bro oi. . hahaha..maka laway mn kaayo..emaxx-mcp61d3 na board imo gamit bro?murag ubos rsad pod imo voltage bro..hehe..pero pyter!pila kaha temps nimo nu..

[werty]

kinsa nakasuway ug oc athlon x2 250 w/ emaxx mcp61d3-icafe??how did it go??or better yet,is this board good enuf? i can't find any results sa google ky murag this is a cheap board.. sa ako ning nephew..ako lang practisan oc..

kung naa ht adjustment and cpu voltage adjustment imo mobo-bios, aw daug...

[KH0UJ]

unsa nga board imong gamit sir? stable ni siya, murag ubos lageh imong core voltage... TIA

M4A78 Plus bro, di sad ko kaingon nga stable bro kay medyo dugay2x siya maka ON sa unit ako rang gitestingan kung asa gyud siya taman mapuga sa akong board, mahadluk sad ko mo-test ug 24 hours kay naka stock cooling ra

ngiloha ana bro oi. . hahaha..maka laway mn kaayo..emaxx-mcp61d3 na board imo gamit bro?murag ubos rsad pod imo voltage bro..hehe..pero pyter!pila kaha temps nimo nu..

akong gi-ubsan gamay akong CPU voltage bro kay mag cge kog reset sa BIOS kay di na gyud mo boot kung stock voltage, natagbaw sad kog downclock sa akong memory frequency ug palu-ag sa mga timing kay manubra na sa rated freq. niya, FSB man gud ni overclockon bro, lahi ra gyud tong black edition series kay sa multiplier ra, 44 celsius @ stock HSF ni bro, nya paghuman nakog benchmark 59 celsius nya nag hinay2x na sad ug kana-ug into 44 celsius

[rejiel]

mahadluk sad ko mo-test ug 24 hours kay naka stock cooling ra



akong gi-ubsan gamay akong CPU voltage bro kay mag cge kog reset sa BIOS kay di na gyud mo boot kung stock voltage, natagbaw sad kog downclock sa akong memory frequency ug palu-ag sa mga timing kay manubra na sa rated freq. niya, FSB man gud ni overclockon bro, lahi ra gyud tong black edition series kay sa multiplier ra, 44 celsius @ stock HSF ni bro, nya paghuman nakog benchmark 59 celsius nya nag hinay2x na sad ug kana-ug into 44 celsius

idola, stock hsf ra ang gamit...nya 4 ghz?? wowowee... kuyawa gud sir sah, instead of overvolting, undervolt man nuon...

[Ezio_Auditore]

grabeha anang 4ghz oi...

[redfox775]

Overclocking is good kinsay di ganahan ma optimize nimu ang full capability sa imung hardware, this must be done in your own risk, kay masayop kag adjust sa mga default settings, palit bag o jud,may lang ma dag repair... pero for references sa TS share nako ni nga article: AMD Athlon II X2 250 CPU Review - Page 12 - Overclocking, Power consumption & Conclusion

[KH0UJ]

As for the Intel-based system, it just was not in the race this time; it consumed 70W higher at load than the Athlon II system. More and more people try to limit their power consumption for a reason of costs but also for the environment. So here, the Athlon II scores a big point.

+1 Love my OWN

However, it is somewhat disappointing that the Athlon II cannot manage higher memory frequencies; it is limited to DDR2-800 or DDR3-1066, compared to Phenom IIs which can run DDR3-1600 without any problems. Memory bandwidth is greatly reduced; SiSoft Sandra revealed 2/3 of a GB/s were removed compared to the Phenom II which ran the memory at 1333MHz.

nabuang sad gani kog set sa memory abi nakog sa akong chipset ang naay barrier, ang mismo CPU gyud di-ay