Mini 4wd Q and A section

[Metz]

---

1. FRp - Fibre-reinforced plastic (FRP) (also fibre-reinforced polymer) is a composite material made of a polymer matrix reinforced with fibres. use to protect the chassi of your mini..
2. depende ra na nimu bai.. but for me i cut it at around 4mm

when you say 4mm, mao nalang ang mosiwil right?

[skye_chelene]

up for the minis!!

[DREAMWERXS]

hi guys, ask lang ko if ok ba ni siya nga charger?

newstar ntc 39
ntc 39

[shamo]

mga master mag reinforce ba daan before e set ang angle sa wing?

[towperuX]

kinsa ako pwede ma storyaan about 4WD set up? i want to go back to this hobby and i want to know everything on this since wala nako kbalo ani...thanks!

[ajlago]

kinsa ako pwede ma storyaan about 4WD set up? i want to go back to this hobby and i want to know everything on this since wala nako kbalo ani...thanks!

naa sa guadalupe atbang fooda. naa sad si jayburn. naa diri sa istorya.plihog lng ko check sa buy and sell forum... naa sad si eric go naa sad sa buy and sell forum

[cebulifer]

newbie here, patabang jud ko kay akoy kutikutihon sa ako soon to be 7 year old son.
Puro palang technical kits ako gisetup nya hinay hinay rapud.

questions:
2. I recently added breaks sa usa ka kit, but kabantay ko dako ang sobra sa "eraser" and cge sila recommend nga putlan kuno. Pila ka mm ang ideal range ani?

First off... it's BRAKES.

What I do is insert the eraser to the max. then I place the mini at the edge of the table. the extra eraser that you need to cut would start from below the table surface. i use a marker pen to place a mark where I should cut. pull out the eraser again and cut it, leaving about 2mm allowance. that's the time when you would use your sand paper in your calpad for the finishing touches.

[f3a_champ]

kinsa ako pwede ma storyaan about 4WD set up? i want to go back to this hobby and i want to know everything on this since wala nako kbalo ani...thanks!

Unsa man nga category imong gusto apilan? Tech, Speedtech or super high speed?? Kung Speedtech gani, unsa man nga class, Tamiya motor or open motor?

[carlangeluh]

mga master mag reinforce ba daan before e set ang angle sa wing?

set daan ang angle sa wings den reinforce.

[Metz]

First off... it's BRAKES.

What I do is insert the eraser to the max. then I place the mini at the edge of the table. the extra eraser that you need to cut would start from below the table surface. i use a marker pen to place a mark where I should cut. pull out the eraser again and cut it, leaving about 2mm allowance. that's the time when you would use your sand paper in your calpad for the finishing touches.

hahaha.

TY.