printer repair shop

[victorvic]

---

If this case is only settings problem try it by your self (trial and error). To print the settings, while pressing power switch hold the font button (load continuous paper) it will print the default settings mode. Just read and understand the steps. Change the Auto Line Feed settings if nothing goes change proceed to Tear Off settings, Page Length settings etc.

[sleepydeepeyed]

dili man bro...Font Button + Operate = dili mo print...Tear off + Operate =dli mo print...ang LF/FF and Load/Eject + Operate = mo print sya...
i tried this one:
THESE INSTRUCTIONS WILL PERMANENTLY ALTER THE TOP OF FORM SETTING

1) Load In A Form or Paper into the Printer
2) Lift the printer cover up and off the printer ( Smoke colored plastic piece on top of printer )
3) Hold down the PAUSE Button for about 3 seconds
The pause light starts flashing and the printer enters micro-adjustment mode
A) Press the LF/FF Button to move the paper up, or
B) Press the Load/Eject Button to move the paper down
4) Press the PAUSE Button to exit micro-adjust mode
5) Put the printer cover back on the printer
...but to no luck...

[victorvic]

THESE INSTRUCTIONS WILL PERMANENTLY ALTER THE TOP OF FORM SETTING

1) Load In A Form or Paper into the Printer
2) Lift the printer cover up and off the printer ( Smoke colored plastic piece on top of printer )
3) Hold down the PAUSE Button for about 3 seconds
The pause light starts flashing and the printer enters micro-adjustment mode
A) Press the LF/FF Button to move the paper up, or
B) Press the Load/Eject Button to move the paper down
4) Press the PAUSE Button to exit micro-adjust mode
5) Put the printer cover back on the printer
...but to no luck...

I think this is the answer of your problem just press the Load/Eject Button several times or equivalent to 1/2inch then press the pause button to store the change of settings.. turn-off your printer then test.. hope will work.

[sleepydeepeyed]

yup as i said ..this instruction didn't avail...still problem occur...kinda weird.this problem started when the printer encountered all lights blinking error and sometimes no power..wat i did was i tried cleaning the logic board with water and detergent..thanks..any idea?

[IT]

yup as i said ..this instruction didn't avail...still problem occur...kinda weird.this problem started when the printer encountered all lights blinking error and sometimes no power..wat i did was i tried cleaning the logic board with water and detergent..thanks..any idea?

blinking error? isn't epson? please post the model, thanks.

[Redman]

Bro try Xcomp Computers sa skina Banawa atbang jolibee...2625155 to 57.......loook for greg

[sleepydeepeyed]

no fix no charge ?

[victorvic]

outchs...... naa diay history problem ang imo printer I thought wala.... Try nalang pa check sa tech... source out lang sa tech nga ma sabot nimo..

[istoryanimo]

dili na sakto iyang feeding....mo lapas na sya ug 1/2inch...mao ra gyud na problem niya...if ako iadjust dili sya maadjust pabackward pa forward lng.

wla siguro na timing sa mechanisim... na paper jam na before?

[sleepydeepeyed]

yup wala na timing cgro ni...wala ni na paper jam...nag "ALL LIGHTS BLINKING" ang error ani..kana bitaw inig ON mo blink tanang LEDs. na ayom ayom ra to nako karon kay ang line feed napod ang problema...