VC Problem

[bolivar1985]

---

Good day,

Guys need you advice,
i got a vc ati radeon x1300 pciexpress
my problem is that after windows xp loading my monitor would try to find the vc, but could not find it, but when i used the on-board video, it is ok.

history of this vc is about 3months have not used it, last time i used it, it was ok, now when i used it that's the problem, kutob ra siya sa windows loading den mo itom lang ang screen den mo gawas ang dvi or vga bana.

it would be nice if any advice would do.

thanks

[poldopunk]

bad card. pretty hard to diagnose what the problem is at this point (assuming the card really is defective). 'could be an issue with one of the components (GPU, memory, bus, etc.) or something as simple as the connector being broken.

to confirm if it really is the card that is at fault; try a known-good card in the same port because it could also be an issue on the motherboard.

[simoko]

or try that vcard on another pc..kung kaging, then its really the vcard...

[crossramz]

try daw set sa imo cmos bro... basin naa ka na overlook didto.. sayagn man gud kung mag ilis ka ug vcard..

[bolivar1985]

yeah sayang gyud. even thought extra card ni nako.
so here what i did, i put another vc to my mobo, it was fine, it run,
i haven't tried the vc to another mobo. i will try it later.

[cloud]

Good day,

Guys need you advice,
i got a vc ati radeon x1300 pciexpress
my problem is that after windows xp loading my monitor would try to find the vc, but could not find it

thanks

could be your windows installation (driver maybe) ... cause the problem comes up "after windows xp loading"

[Dondon]

Could be resolution problems pud bai, it was set higher than the max resolution sa imong monitor.

Inig boot-up, press F8 (like how you get to safe mode) then choose "Enable VGA mode" or "Enable low resolution" or basta kato kalimot lang ko sa wordings.

Of course pangagpas ra ni'ng ako-a. Kay makita paman kaha nimo ig loading so di gyud siguro guba ang card.

[moklo]

Uninstall usa sa imong driver dayun restart and boot to safe graphics mode unyah didto i install ang driver dayun restart.

[bolivar1985]

will do it later,
yeah i already uninstall the previous driver.(same problem kutob ra kahuman og load sa windows xp)
i'll try your suggestions...

[bolivar1985]

will try this once i get home...
yeah ok ra kaayo sugod kana ipa kita niya imo motherboard ram processor og harddisk, ok sad ika sulod sa bios, ika human lang gyud load sa windows mo off siya then mo gawas dayon kana bitaw wala na connect ang wire sa monitor sa imo pc.

Could be resolution problems pud bai, it was set higher than the max resolution sa imong monitor.

Inig boot-up, press F8 (like how you get to safe mode) then choose "Enable VGA mode" or "Enable low resolution" or basta kato kalimot lang ko sa wordings.

Of course pangagpas ra ni'ng ako-a. Kay makita paman kaha nimo ig loading so di gyud siguro guba ang card.