Cebu PCTech Association

[ISDA_SA_BATO]

any idea mga bro,.naa koy mobo Asus P5KPL-AM SE, nikalit lang kawala ang display sa monitor, i'd check everything,i'd try to use other monitor but still no display,.magblink2x ra ang light sa monitor if i turn-on nako ang unit.,everything is working fine on the system, fan, beep, HD-light.,duda nako it boot normally but wala lang jud siya display mapakita.,it's weird,.unsa man usually problema ani?,.,kini ang akong suliran, hinaut mahatagan ninyo ug kasulbaran, ug matambagan sa hustong sulosyon,...

daghang salamat,.looking forward for more feedback,.weeeeeeee

[dartzed]

1. do monitor check: good working monitor should have an output "no signal output/display" during power on.

2. check broken/defective graphics accelerator:

if you are using an add on vcard: either use the on board graphics accelerator or try it on other vcard; if still the same then something is wrong with your mother board.

if you are using on board: use an add on graphics card(if you have extra); if still the same then something is wrong with the motherboard.

[benicio]

gicheck na nimo sa lain nga cpu ang monitor?

[togoys]

u said bro ni "beep" ryt? meaning everthing is ok pag POST nya.. . pero ang naka parat lay display..try lain kuno monitor e.interchange pud onboard ug dedicated nga v.card dn kng nag dvi ka or hdmi try kuno vga e.try2 lang gud syaro... hehehehe..

[marcial19xx]

change VC or use on board video...

[ISDA_SA_BATO]

toink!<.gitry na nako na tanan inyong suggestion bro.,but have no luck, duda nako ani memory,.wla pa ko kalugar lakaw gud palit,,.hehehe i try lng nako,.

tama si togoyz, it boots normally,kaso wla lang display,.

anyway,.i did not use any external peripheral devices, it's just an usual system, built-in ang vga,.kutob sa mapangitaan ug remedy to work go but if wla na jud choice, maybe palit nlng jud ko vcard ani...hehehe

[marcial19xx]

lahi man kung memory ang guba ana... dli man jud na cya mo boot... lahi ang beep ana kung memory error na cya...

[aimbots]

mga bro, apil ko ha..

[ISDA_SA_BATO]

@marcial: naka encounter man gud ko sauna, nagpa repair sa akoa sauna,.no display with normal boot.. ako lng gi limpyohan ang memory then it works fine,.
naa man gud uban mga board nga dli mo beep bisan nay defective, it's just wla lang.,naka encounter pod ko nga 2 ka-slot sa memory was inserted with two memory card then no display, gi-try lang nako tagsa2x ug inserted then it works fine, so conclusion, if two memory card is inserted then one is defective, the system will be affected,.that's what i'd encounter bro,.it's all about memory pero i dunno sa uban pa,.we will find a way,.bag-o paman gud ning mobo ani, less that a year pa.

[marcial19xx]

ok kun mao na imo diagnosis... remove all the memory from the board then turn it on... ato tan-awon kun unsa ang iya error beep... ok