Is This Possible (to Modders)

[werty]

---

your room temp should be cooler compared to your case temp. if mag ducking man lang, should it be better to get air from a cooler source, say outside from case then exhaust it at the back?

[werty]

OT
@eves
u cant gain post doin that. ma block ra ni imo account...

[istoryanimo]

Ok kaayo idea.. under warranty pana or just pm COMCAM, he will give you an idea/suggestion instead.

[robo0808]

Doable na siya using acrylic and acrylic bender. Nichrome wire gamiton para pag bend sa acrylic.

[COMCAM]

Gr8 thinking bro! I call that D.A.D. - Directed Airflow Distribution hehehe. Robo is the right man for that job. He has the skills as well as the experience on acrylic bending.

It might lower your temps better. I'm seeing a 1 to 3 degrees less in temps.

[Rainerius]

Gr8 thinking bro! I call that D.A.D. - Directed Airflow Distribution hehehe. Robo is the right man for that job. He has the skills as well as the experience on acrylic bending.

It might lower your temps better. I'm seeing a 1 to 3 degrees less in temps.

I confirm it did lower my temps by 4 degress in Furmark. I make sure lang tomorrow kay I don't want others to do this nya dili nya worth it. I am using a crappy 80mm fan (approx mga 20 CFM) using the 2nd design sa first page. I will get the Silverstone 80mm that can reach 70 CFM ugma and it should lower the temps more. Daghan pod leaks akong card board shroud kay gi dali2x nako (ugma napod ang pics).

[[-erick-]]

sige daw bro if okay ni...

naa ko 3 ka fm123 dinhi on standby lol.

[mil]

@rainerius
nice find brad.. might give this a try. thanks. =)

[COMCAM]

rain, have you recorded your ambient temperature when you did your experiment?

[Rainerius]

rain, have you recorded your ambient temperature when you did your experiment?

Daghan pa jud kulang bro, gi dali2x jud nako daghan kaayo ko work gud. I am working on a model using Blender first to fit a bigger fan maybe 120mm. Post nako ang rendered image if mahuman.

Kadali lang mga bro ha kay busy kaayo sa work...