tarunga imng 80 pin IDE cables bacin nasipyat ka sis..
- Blue: The blue connector attaches to the host (motherboard or controller).
- Gray: The gray connector is in the middle of the cable, and goes to any slave (device 1) drive if present on the channel.
- Black: The black connector is at the opposite end from the host connector and goes to the master drive (device 0), or a single drive if only one is used.
then check your jumpers also bro mao man nay cause mo hang ang system usahay...
tingale you are using very old hardrives..
you might want to review on this...suggestion lang...
Mikes Hardware | How To | Connecting IDE Hard Drives