share sd mo beh....

[poldopunk]

---

since when man ang beep codes mo report ug bad proc?

[flipdruid]

Try mo bro mao ni nag steps.. giresearch ko ani..
Step1
Swap the processor. Remove the processor that seems to be problematic and install a spare or remove one from a working machine, if you have one. If it still doesn't work, you have other problems. If your machine works with the good processor, take it out and put your original one back in. If it still does not work, you will need to replace the processor.

Step2
Attempt to turn on the computer. If it does not power up at all, check the processor fan and see if it turns. A nonworking fan will cause the processor to overheat.

Step3
Turn your computer on and let it run for a while. Turn it off and open the case. Following the manufacturer's instructions, use an anti-static wristband to ground yourself. These wristbands are available at most office supply and electronic retailers. Carefully touch the processor. If it is too hot to touch for more than a few seconds, your processor is overheating.

Step4
Try installing or running an application. If they will not install or run, update your computer's drivers. Contact the system's manufacturer for current driver downloads.
Step5
Replace the motherboard, if you are comfortable doing so. Check the "Resource" section of this article for a detailed instructional video. Try replacing it with a spare or one from a working machine if you have one, or purchase a new motherboard. Your current motherboard may be bad or incompatible with the processor.

[flipdruid]

Sumpay mga Bro..

Step5
Replace the motherboard, if you are comfortable doing so. Check the "Resource" section of this article for a detailed instructional video. Try replacing it with a spare or one from a working machine if you have one, or purchase a new motherboard. Your current motherboard may be bad or incompatible with the processor.

[reishoto]

bro, if guba na gyud ang procie, la naka beeps k una mana i-initialize kung nag power on ka...

dead procie, means dead mobo, everything else will be unusable...

[tikong008]

dba mga bro naa mn slot na butangn sa proc...dba naa mn mga pins ana..naay nabali 2 kabuok..madala pa kha ni og au or good as dead na jd ang mobo?