Airsoft

[ArCkz]

asa ta dapit mag pa himo ug crane stock na configuration sa battery kinsay nakabalo? ako plan unta kay 9.6v 8 piece sub-c batts, naay lain alternative beside sa bat kingdom?

try sa All Batteries

[Deanmonyo]

hmm asa na dapit ang all batteries? pareaha ra sila ug rate sa battery kingdom?

[hatebreed77]

pila ang price sa bell na beretta gas gun?

[middleman]

nahan ko pataas ROF by changing my battery but kuyawan ko mag lipoly....unsay alternative ani? unsa man nang sub-c? nicad?

[rodsky]

nahan ko pataas ROF by changing my battery but kuyawan ko mag lipoly....unsay alternative ani? unsa man nang sub-c? nicad?

First off, unsay current voltage sa imong battery pack? And if the size of each cell (diameter) is same as a Standard Alkaline AA, then your battery must be NiMH. Sub-C's are larger batteries and are usually NiCAD, but that doesn't mean nga it's more "powerful". Look for the mAh rating--if it's something over 1500 (i.e. 2500 or 3000), then it's long-lasting, and can also mean that you will have higher ROF, because of the "pressure" of the voltage. But the normal rule of thumb is, the higher the voltage, the faster the ROF. You can increase voltage by adding another cell in the pack, but make sure it's same exact battery as the other cells--this will work with both NiMH and NiCAD.

-RODION

[middleman]

stock ma ni cya sa JG..(8 ka 1.2V) 8.4V n 1100mAh..NiMH. pila man ka volts ang kayahon sa stock nga internals? unsay pros and cons sa NiMH and NiCad?

[Deanmonyo]

nimh no need to discharge after using, nicd discharge after using. if you want high rof go for lipoly

[rodsky]

stock ma ni cya sa JG..(8 ka 1.2V) 8.4V n 1100mAh..NiMH. pila man ka volts ang kayahon sa stock nga internals? unsay pros and cons sa NiMH and NiCad?

Stock JG internals usually have plastic bushings, so if you increase voltage up more than 8.4v, yes you'll have higher ROF, but the bushings will wear down faster. So before you plan to increase ROF (by changing the entire battery pack or adding a new cell), make sure you already have metal bushings and proper shimming.

-RODION

[middleman]

ahh ok...mao pd na akong gi planohan rn, bushings n shims....thanks sirs rodsky and deanmonyo.

[Deanmonyo]

no problem sir im still about to explore lipoly since i envy my frends high rof using lipoly