DDR2 1.8V & 2.2V

[bryan]

---

Meaning this Memory Card voltage rate represent as range? I think ma consider sad ni tingali... like PSU that could handle 220-240 volts...

im not sure bro... maybe

[emoners]

Actually bro if adto ka sa crucial.com maka-kita ka didto og DDR2 667 @1.8V & 2.2V. & also specs ni sa Memory modules ang ako pasabot nga voltages. I dont have any idea makita bani sa bios or windows. Try visiting the website & look for DDR2 667.
Thanks for the info!

ah ok...so you're talking about the rated voltages sa imong mems... 1.8-2.2v ang voltages you're mems were tested by Crucial.
you noted man gud slot1+3 @1.8v slot 2+4 @2.2v... mao na naglibog ko
you set the speed & voltages sa mems sa bios. if you set them, then maparehas na na sila voltages & speed.
or if you don't set them, your mobo will set them at default speed & voltages lang.
since these sticks are micron D9GMH, i would suggest you don't go beyond 2.2v for 24/7 use... pwede a little bit above for short benches.

this was my run some time ago... Crucial Ballistix PC-8500 @ 620Mhz x2 (1240Mhz) with 2.15v http://valid.x86-secret.com/show_oc.php?id=290878

[EarlZ]

Actually bro if adto ka sa crucial.com maka-kita ka didto og DDR2 667 @1.8V & 2.2V. & also specs ni sa Memory modules ang ako pasabot nga voltages. I dont have any idea makita bani sa bios or windows. Try visiting the website & look for DDR2 667.
Thanks for the info!

Earlz,
thanks!

Im not 100% sure but JDEC standards for 667 is 5-5-5-15-2T, Crucial can either have that or a much tighter timings at 4-4-4-12-2T hence it would require 2.2v w/c is perfectly normal.

[bryan]

ah ok...so you're talking about the rated voltages sa imong mems... 1.8-2.2v ang voltages you're mems were tested by Crucial.
you noted man gud slot1+3 @1.8v slot 2+4 @2.2v... mao na naglibog ko
you set the speed & voltages sa mems sa bios. if you set them, then maparehas na na sila voltages & speed.
or if you don't set them, your mobo will set them at default speed & voltages lang.
since these sticks are micron D9GMH, i would suggest you don't go beyond 2.2v for 24/7 use... pwede a little bit above for short benches.

this was my run some time ago... Crucial Ballistix PC-8500 @ 620Mhz x2 (1240Mhz) with 2.15v http://valid.x86-secret.com/show_oc.php?id=290878

bro nindota nimo og Mobo & processor

[emoners]

bro nindota nimo og Mobo & processor

nindot man sad imo bro...depends lang jud on how you use it
so musta na rams nimo?

[bryan]

nangita pako sa tipid pc bro.

[matok]

what is the lowest voltage setting you could set this mem @1066mhz?
or would it depend on the mobo also?