Modding newbie... ~dom

[gregggy_ph]

---

nice mod...
gee...i hafta re mod my case coz i f'ed it up really bad..i made holes wid out a circular saw...hehe...my painjob is darn bad...i hav to sand it all again...

[jonz]

nice rig 0_0
OT:
ako pud g in ana ako casing... generic ATX X-blade casing
i also dig a hole at the back side and put an exhaust fan(2X.20amp)
then one in the side panel.. i also remove the X, i put a lil bit huge inhaust fan(1X.52amp) i also painted black pylox gloss the front part
planning to spray the inside part with flourescent paint il post a pic when im done

[dom_08]

@AMD_infinium05æ

yup... drill only... drill around the circle, side by side...

@seekenneth

ok.. i'll post some pics.. please, be prepared for rough hole... ^_^
for me it is ok, since it won't be noticed, after the fan guard is installed... ^_^

by the way, i also used a round file to smoothen it somehow...

@gregggy_ph
thanks... ^_^

dat's ok...
i also made a hole without a round saw... just my good ol' drill..
to be honest, my paint job also has flaws... and need to be refined/resand and paint... ^_^

@jonz
looks like a nice mod, i'll wait for your pics... ^_^

[dom_08]

btw...
all pics are links... just click them...

sorry, if they are scaled down to 800*600... because i am only using dial-up, and besides, i dont want to slow other computer's connection.. ^_^

[seekenneth]

@jonz - intake fan, no such word as "inhaust" lol. peace :P

@dom_08 - what tool did you use in cutting the x on the sidepanel again?, i cant find the post that has the tool listed :P sorry. and where did you buy those paint prays. the case is very nice!!! like it. gonna murder my case later bwiihihihih :P

[jordinho]

ayos

[dom_08]

@seekenneth - yup... no inhaust, should be intake... ahihi

-i used hand saw for metals (lagaring bakal) that you can find in any hardware store...
as for the spray cans, you can buy them at any Ace or Handyman... ^_^

[dom_08]

@seeknneth

here are the tools i used...

1.) drill set to low speed: for the blowholes
2.) round file: to smooth out the jaggies of the blowhole
3.) screwdriver
4.) patience (lots of patience)
5.) creativity (hehe.. i think, i was not able to use this)
6.) hand saw for metals (lagaring bakal): used for the X part of my side panel...

you can buy the spray cans at ace hardware...

[dom_08]

@jordinho

thanks... ^_^

[dom_08]

closer look at the blow holes as requested...

two more to come...