Lapping a proc.

[etgo]

---

effective ba kung kiskisan ang proc? if so,

unsay gamiton pag kiskis? pwede ra liha? unsay mahitabo kung masubra-an?

[etgo]

apas..

unsay pro and cons kung kiskisan?

[vladmire]

void ang warranty

[spookey]

lapping will have a better heat transfer since by default procs are not so flat. and yes, it will void your warranty.
lapping is done usually by using a small grit to very fine grit sandpaper. this means that you will have to use a few different sandpapers.

[vladmire]

try lapping if it is already out of warranty para dli pud ka magmahay kung madaot,..

[mason]

hhhmmm..... theres a purpose pud cguro why manufacturers proc covered with nickel?

[vladmire]

hhhmmm..... theres a purpose pud cguro why manufacturers proc covered with nickel?

design ra nang nickel

[[DSX]]

unsa diay kaguba-an sa heatsink? heheh ngano ma problema man mo sa warranty.. if it works.. it works.
kung mag lap mo.. depende sa roughness sa finish sa heatsink -- diha mag base unsa ka kadako nga liha mag sugod.. try around 4 levels of lapping. the last being the finest grain. one technique in lapping is to use a mirror or flat glass as your base. tape the sand paper on the glass and slowly work lapping your heat sink. also do wet lapping.. meaning add water while lapping. dont exert pressure. let the weight of the heat sink do it.

[raymacsor]

]
unsa diay kaguba-an sa heatsink? heheh ngano ma problema man mo sa warranty.. if it works.. it works.
kung mag lap mo.. depende sa roughness sa finish sa heatsink -- diha mag base unsa ka kadako nga liha mag sugod.. try around 4 levels of lapping. the last being the finest grain. one technique in lapping is to use a mirror or flat glass as your base. tape the sand paper on the glass and slowly work lapping your heat sink. also do wet lapping.. meaning add water while lapping. dont exert pressure. let the weight of the heat sink do it.

bro murag processor man tngale dli mantngale heatsink

[mason]

design ra nang nickel

in thios case, dili nalang ta e coat ug nickel ang proc, maka save pa ang manufacturer..