kana awata kay 45degress/135 degress ang LTE, same sa gihimo sa thread starter... see first post boss...
sa imo antenna pole kay T-type man, kani awata purpose ra man ana para maelevate booth antenna at horizontal level
then kani pagkahipos sa cable limpyo tan awon, gigamitan nag rubber tape to seal the connector, basta after nimo apply rubber tape imo pud apply ug electrical tape para dli malata ug malanay/mahulog/modisintegrate ang rubber tape... brand nga nindot kay nitto, then 3M ang presyo naa sa 100php, then pwede na Omni sa Electrical tape
image source from uplift BTW...
edited...same ta ug napost boss...hehehe
Remount lang nako ugma. Thank u again boss @Vino Kid
1. Apply the self-amalgamating (self-fusing) tape approximately 50 mm below the lower edge of each connector. Overlap each turn by 50%. Proceed all the way up ma-coveran ang connector maybe 30mm above connector...
other term (rubber tape)
2. Apply two, half-overlapped, slightly-stretched layers of insulation tape. Other term Electrical Tape
For each layer, start 30 mm below the lower end of the self-amalgamating (self-fusing) tape and proceed all the way up masapawan ang rubber tape...
basta sugod ka sa ubos going up magbutang ug tape para ang layer niya naa sa ubos, iwas matambayan ug tubig or other foriegn materials... check orientation/position sa imo cable para dili baligtad pag butang sa tape..
no prob boss @jhnpl
maliit na bagay heheheh... bitaw sharing is caring... hekhekhek...
share lang ko sa ako nakat unan sa trabaho boss, dagko lang na waveguide ako exposure na kinahanglan walay moisture/foreign object mosulod or sobraan lubag kay bagsak inig sweep test... dili ra ba mamakak ang test equipment... unsay di makita sa tao, makita sa test equipment..
After reading jonmlas & Vino Kid posts... I'm already in the process of purchasing 2 Parabolic Grid Antenna! \m/
question lang.. kung full bars na ako b593s-22 using stock antenna..need pa ba ko mupalit ug parabolic dish antenna para mukusog ako internet speed?
Similar Threads |
|