Help mga master sa computer!

[andersonl]

---

on the hardware side, try daw check:
1. thermal paste if dili ra uga kaayu
2. coolant fluid level
3. coolant flow (check if countinuous flow, no bubbles dapat)
4. if the fluid pump is doing it's job
5. radiator heat sink and fan is not too dusty
6. hot air expelled from radiator does not recirculate back to itself

[grimmjow]

ok rana ui...ilis gud og bag-o og maguba haha...

[duty-free]

on the hardware side, try daw check:
1. thermal paste if dili ra uga kaayu
2. coolant fluid level
3. coolant flow (check if countinuous flow, no bubbles dapat)
4. if the fluid pump is doing it's job
5. radiator heat sink and fan is not too dusty
6. hot air expelled from radiator does not recirculate back to itself

Sir ang thermal kay 3 months pa lng na gibutangan ug tuniq TX4.
Unsaon mn pod pag check sa coolant sa antec H2o 620 sir? black man ang hose closed kaayo.

- - - Updated - - -

ok rana ui...ilis gud og bag-o og maguba haha...

basta nay panghatag ilis ko bag-o.hehe

[centaurus]

....600W psu, that's enough for 60% load or end games at 1600

[square.circle]

....600W psu, that's enough for 60% load or end games at 1600

unsa pasabot ani bro? ok rana ako psu? daghn rba ko 120mm fan mga 7 ka fan.

[Echelnalf]

on the hardware side, try daw check:
1. thermal paste if dili ra uga kaayu
2. coolant fluid level
3. coolant flow (check if countinuous flow, no bubbles dapat)
4. if the fluid pump is doing it's job
5. radiator heat sink and fan is not too dusty
6. hot air expelled from radiator does not recirculate back to itself

^^ Kani bro. E check lang.

daghn rba ko 120mm fan mga 7 ka fan.

^^ E check kung waLay obstruction. Basin naa ga sugat nga hangin diha sa suLod.

[centaurus]

unsa pasabot ani bro? ok rana ako psu? daghn rba ko 120mm fan mga 7 ka fan.

it seems loaded imu rig...na try na nimu CPUZ?...
Finding out what the TDP or your CPU or GPU is can be as simple as doing some searches by searching for ‘i7 2600k TDP', ‘GTX 580 TDP’, or ‘AMD 6970 TDP’. Remember to account for all components…if you run a multi-card graphics setup, you need to include the TDP values for all cards in the total. For example, our i7 2600k has a stock TDP of about 95 watts at 100% load (estimated). If we have a 2x SLI setup of GTX 580’s, we are looking at about 244 watts at 100% load, per card. Total? About 583 watts in heat that these three components can potentially produce when at 100% load, simultaneously; it's also safe to consider that heat dissipation can never be 100% efficient of power consumption, so even calcuating 85-90% of your TDP total is pretty safe. (This also translates very closely to wattage when you need to consider a power supply for your system, but you need to account for the remaining components: motherboard, fans, hard drives, DVD drives, etc. To help calculate a full system TDP, you can use a tool like the Extreme PSU Calculator. In short, when calculating loop TDP, simply add up the total values for components being cooled in the loop...if you have more than one video card, make sure you add in TDP for each one. If you want to simply calculate the overclocked TDP wattage of your CPU, just adjust the CPU section of the calculator or utilize the calculation listed a bit later

[square.circle]

^^ Kani bro. E check lang.

^^ E check kung waLay obstruction. Basin naa ga sugat nga hangin diha sa suLod.

Duna jud gasugat sir...ang usa ka 120 fan sa ibabaw kay gi- intake man nako. ..exhaust mn ang radiator sa rear.

[Echelnalf]

Duna jud gasugat sir...ang usa ka 120 fan sa ibabaw kay gi- intake man nako. ..exhaust mn ang radiator sa rear.

Baliha lang na bro. Ang mga naa sa ibabaw kay exhaust lang jud na. Front og side lang ang intake. Dapat free fLowing ang hangin sa suLod. waLay dapat ma pundo.