Brod e try ug reset imung bios baliha ang battery. Then, limpyuhi imung ram..ug dili e scan basin virus na...ug dili jud try ug format
Brod e try ug reset imung bios baliha ang battery. Then, limpyuhi imung ram..ug dili e scan basin virus na...ug dili jud try ug format
dugay mo boot means naay gi read ang OS nimo... When booting, try to remove all removable devices like external HDD and other removable hardware... usually mao nay reason why madugay ug boot ang OS.. Try to remove your extra hard drives except your main drive where your OS / drive C: was installed... If mo kusog na gani ug boot, it means one of your extra drive is defective or not functioning well... If the problem still persist, then sa imo na jud nang main drive... When booted to windows na gani ka... try to run Check Disk on your hard disk... scan and repair your disk bro...
dili sa ubang components ang guba ana... Hard disk ra jud na basta dugay mo boot... kanang nag gamit ug SSD instead of HDD paspas kaau mo boot ila PC... but then ilang SSD is the main drive plus another HDD as a storage, there are several seconds delay in booting... the more HDD installed, the slower your PC boots... I have one 500gb as my main drive and two 1tb HDDs as my storage.. considerable jud ang delay when booting than sa katong main drive ra ang gi connect nako...
Try to install a defective or dead external hard disk... your PC will not boot... mo ungot na sya... kay iya man jud na i try ug read bisag dead na... hope this helps..
Try to check ang CMOS battery bro basin weak na ang imo battery.
@Arch thanks. i'll try later... maybe sa magic jack to nako, try nako remove then on.
naka suway ko aning pa agiha gitudlo ra pud sa karaang technician.. balihon ang cmos batt or e remove then turn on.. turn off then e balik sa original..
OnT: TS kung na try na nimu tanan gi suggest dre pwera sa PSU, basin mao jud nay problema.. naka try pud kog ana na problem sauna naa mi gi set up na unit sa Aboitiz na hapnan na lang mig troubleshoot sa VCard, HDD, Ram ug MoBo.. resulta ang PSU diay kuwag ug 5V+ na output..ang nka solve kay ang SR. technician, siya pud ng tudlo nako anang cmos e remove or balihon..
Ok na ni TS? First try check psu kung mao ba jud issue, tried also before ilisan ra nako lain PSU, kung mao gihapon, check ram, kung wala gihapon reformat, kung wala gihapon basin ang HDD jud sugmaton... Hinay-hinay lng gud until ma isolate jud ang problem...
try repair windows or reformat... =)
Similar Threads |
|