Cisco router configuration

[netcommando]

---

ok...

there is no ip route defined & subnet mask wildcard on acl is incorrect

[netcommando]

Help!!! wa jud ko ka connect sa internet aning nga config. pls help review unsay kuwang or problema. Thanks.
----------------------------------------------
DSL_Router#sh run
Building configuration...
!
hostname DSL_Router

!
no ip dhcp use vrf connected
ip dhcp excluded-address 10.10.10.1
!
ip dhcp pool DHCPPOOL1
import all
network 10.10.10.0 255.255.255.0
dns-server 4.2.2.2 4.2.2.1
default-router 10.10.10.1
!
interface FastEthernet0/0
description $My-LAN$
ip address 10.10.10.1 255.255.255.0
ip nat inside
ip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet0/1
description $MyDSL-WAN$
mac-address 00xx.xxxx.xxxx (gi-clone na ni nag mac-add pero wa gihapon pulos)
ip address dhcp
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
!
ip http server
no ip http secure-server
ip nat inside source list 10 interface FastEthernet0/1 overload
!
access-list 10 permit 10.10.10.0 0.0.0.255
!
end

DSL_Router#

[Norad-II]

Pag tcpdump daw sa eth0/0 then sa 0/1 para makakita ka ug asa ma sangit ang packet?

[Norad-II]

Haha, oops! Sorry, wala man diay tcpdump ang IOS. Nah, nagpa-ila lang jud nga wa na jud koy nahinumduman about router configuration. Paka uwaw lang ko.

[netcommando]

ok na ni brad... router reset power cycle lang kuwang.

ako sad gipun-an ani nga line "ip route 0.0.0.0 0.0.0.0 dhcp" kay mag intermittent rto kun wala gi-define nga static ip route

tnx

[tazacar]

default route ra kulang ana pointing to your gateway provided ni ISP or outside interface