Corsair H50 fan configuration

[zhieg]

---

katong nai h50 with dual fan bah unsay configuration ninyo?

and also asa man ta maka palit atong tagas na screw sa h50 pra mahimo nko dual fan..

[dhekoy33]

try sa mga hardware nga duol sa inyoha dalha lang ang original screw,ang configuration is ang fan na intake is padulong sa radiator unya another fan nga modikit sa chassis is pagawas ang labay.

[dootmars]

I used a dual fan configuration when i was using my H50..dual fan nya paggawas ang flow. For the screws, go to Cebu Bolt Center..kilid sa USJR. Daghan pa gani kaau kog salin dre..hihi. Just a tip.. apili ug washer in case tag-as ra ang bolts pra dili masangko sa radiator fins.

[eXpLoDe]

wala d i ka nibasa sa manual? o 2nd hand ra imong napalit?

source: Hydro Series

The screw thread and length are 6 x 32 x 1 1/4"

#6 machine thread, 32 TPI (threads per inch), 1.25 inches in length

[eXpLoDe]

“Push” and “Pull” Defined
Many users ask about the terms “push” and “pull”. This simply refers to a fan pushing
air into the radiator or the fan pulling air through the radiator. The stock single
fan configuration is a push setup with the single fan pushing cool air from outside
the case into the radiator.
Adding a second fan, as seen below, results in the second fan pulling the air
through the radiator. A push-pull set up bringing cool air into the radiator with 2
fans is an excellent set up for cooling your CPU. Ideally, you will need to use 2
identical fans to avoid any of the airflow issues that can arise with using 2 fans
that have different airflow characteristics.
Most fans have directional arrows indicating fan blade rotation and airflow direction
as circled below. Note that the “pull” fan on the right has been modified. A
corner of the shroud has been cut away to clear a heat sink on the motherboard.
This is a common solution to clearance issues.

[zhrike]

butangi lang jud og washer bro para naa clearance gamay dili mag-sabod2x

[weezur]

di ni pwede tag duha lang screws both sides nya diagonal? wa ra ko ni bother butang sa ako gepalit long screws sa True Value.

[dootmars]

@weezer

Pwde ra man bai. Ingana mn to akoa sa una ky kapoy cgeg kuot2 sa screws basig maigo sa screwdriver ang board..patay static. Pwde ra kaau 2 on each fan basta diagonal lang.

[simoko]

I used a dual fan configuration when i was using my H50..dual fan nya paggawas ang flow. For the screws, go to Cebu Bolt Center..kilid sa USJR. Daghan pa gani kaau kog salin dre..hihi. Just a tip.. apili ug washer in case tag-as ra ang bolts pra dili masangko sa radiator fins.

ok ra na masangko & mapilo ang radiator fins...NO LIQUID COOLANT flows in there...

[dootmars]

Aww..ok r diay na bOss? Ang ako lng ky basig madisrupt ang airflow ig mapilo ang fins(ako2 ra ni)..hehehe.