How to know the settings of my DSL modem when use LINKSYS router BEFS41?

[pa0pa0]

---

guys and gals, do u have any idea of what's the first thing to do when configuring my new LINKSYS router?

[ForYou]

Refer to the router manual bay or sa linksys website...
basta ako lang ma offer nimu is how to access the GUI of your router to start configuring it...
For WinXP OS:
1. click start > run > type "cmd" & enter > type "ipconfig" & right down the "default gateway number" (e.g.: 192.168.1.1) > type "exit" to close command prompt
2. open internet explorer > type the "default gateway number" in the address bar of internet explorer
3. If it will ask for a username & password, leave username blank & type "admin" (all lowercase) for password
NOTE: If it will not work, refer to your manual/linksys website.
4. Now your inside your linksys GUI... next thing to do is refer to your manual/linksys website.

One Tip!: If you're using a PPPoE connection, try to figure out to where you want to configure it... either in your DSL modem? or your router? or in your computer?

Good Luck bro!... Just PM me if you have any concerns. Aju2x!

[pa0pa0]

Refer to the router manual bay or sa linksys website...
basta ako lang ma offer nimu is how to access the GUI of your router to start configuring it...
For WinXP OS:
1. click start > run > type "cmd" & enter > type "ipconfig" & right down the "default gateway number" (e.g.: 192.168.1.1) > type "exit" to close command prompt
2. open internet explorer > type the "default gateway number" in the address bar of internet explorer
3. If it will ask for a username & password, leave username blank & type "admin" (all lowercase) for password
NOTE: If it will not work, refer to your manual/linksys website.
4. Now your inside your linksys GUI... next thing to do is refer to your manual/linksys website.

One Tip!: If you're using a PPPoE connection, try to figure out to where you want to configure it... either in your DSL modem? or your router? or in your computer?

Good Luck bro!... Just PM me if you have any concerns. Aju2x!

bro, naa man gud ni daan D-Link router b4 and then nagkaproblema man mao nga ilisan nlng ug LINKSYS na router, saun man nko pag ka hibalo bro kng PPPoE ba ni or what?... NO how jud ko ani!

[ForYou]

Ok... what isp man bay? Pinaka saun buhaton if you want to know if this is a PPPoE connection is calling your isp tech support & ask if PPPoE connection ba ang ila DSL modem.

NOTE: Ask your isp tech support of these ff. info:
- static ip or dynamic ip bah ang imu account?
- PPPoE or PPPoA ba ang connection type ang default settings sa imu DSL modem?
- If PPPoE gani, naka bridge mode ba ang DSL modem before when setup sa DLINK router that they support previously before na guba? Kay basin we need to reset the modem. If so, ask their support to reset your DSL modem & set the PPPoE settings in the modem.
- If ok na, include your router in your physical network connection & make sure you do a sequence powercycle (turn off modem, router & PC... after 10 seconds, turn on back again with the same cycle)

PM me if unsa bay... Aju2x!

[pa0pa0]

id call the support they said that our account is static ip... and i ask for kng unsa ang setting sa DSL modem d cla katubag kay only the technician man nila ang katong nag configure ani na modem ang nkahibalo and physical man gud ni pag configure not like sa account kay mail-han sa support nig tawag. so ang problema pangita-on na sad asa tong technician para muari dri physically to check kng unsa ni nga setting ang modem... lisoda raba bro kay kng manawag ko sa ila number lain naman mutubag murag call center naman nila gi-address.. naa kay idea kng saun nko pag-kahibalo kng unsa ni nga setting ang ako modem?? naa kay paagi bro?? para d nlng ko manawag sa PLDT aron paarion kng unsa ni nga setting akong modem kay lisod kaau ning mga tawahana pangita-on...ako sad plano ako nlng mag configure....pls help.. thanks.

[VampyR]

saun rna bro, i think naa'y installer cd kuyog ana d ba? follow the instructions lng

[pa0pa0]

saun rna bro, i think naa'y installer cd kuyog ana d ba? follow the instructions lng

0o bro naay installer kuyog pero d man kana ako problema sa pagkakaron.. kani man akong DSL modem kay wa ko kahibalo kng unsay settings ani niya..

[aditti]

hey we have the same router and connection... hasul cya..

newai, type 192.168.100.1 to get into the setup sa router

Internet Setup

Internet Connection Type PPoe
User Name: (this would be your assigned num by pldt... eg '12345@pldt) -->call pldt dsl helpdesk at 172 if u dont know unay imo num
Password: depnde unsa imo username (e.g 12345) u can call 172 for this too
Service Name: depende sa username ghapon (e.g. 12345)
Connect on Demand: Max Idle Time Min.
Keep Alive: Redial Period Sec. (check this option.. i put in 120 seconds)



Optional Settings
(required by some ISPs) Host Name: pldt
Domain Name:
MTU: Enable Disable (check disable) Size:

[pa0pa0]

ok... salamat

[softtouch]

What subscription plan do you have with pldt?
Most subscriptions are not pppoe, they are dcp.