Thermaltake Case Owners

[blizzaga4]

---

no need to sleeve boss just wrap the whole 24pin cable with 2 or 3 inch in diameter heatshrink.

Remove adhesive on cables or wires:

From Cables and Wires

* 1
Saturate a rag with household lubricating spray. Wipe down the sticky cable or wire with the rag to soak the adhesive with the spray.
* 2
Let it sit on the wire or cable for about five minutes. Wipe the wire or cable aggressively with the same rag to lift the adhesive. Apply more lubricating spray to the rag and continue scrubbing until the adhesive is gone.
* 3
Wipe down the wire or cable with a rag and clean water. Wipe over it with a dry rag to remove any moisture.

[johnwall]

@eldonex...sir could you take some pics at the back of your motherboard tray?
so that i could have some idea on managing my cables..coz we have the same power supply..thanks..

[gaspar_73]

@sir Blizzaga4
mau jud lage boss,Kerosene or WD40 ra ang makatangtang sa adhesive ani...ang gi-tape nako kay ang pheriperals cable man like 4-pin molex/sata power cables ...ang 24-pin kay as-is ra...tag-pila pud kaha ang per foot anang 2"diameter nga heatshrink tube sa?any idea?

[johnwall]

@gaspar_73..sir wala na garas ang side part sa imong hard disk? pag butang nimo sa hdd drive bay? dba murag huot man kaau inig butang nimo sa iyang drive bay..

[gaspar_73]

@johnwall
medyo hugot jud bitaw,wala na nako ma-check if nagaras bah,,sa floppy drive bay nako gipasok ang hardisk boss,gi-putol nako ang isa ka tiil sa lock.sagabal man gud sa front fan kung sa hdisk bay ibutang.highest temps sa hdisk 39deg. when gaming hard.okay rah.

[play_chess23]

no need to sleeve boss just wrap the whole 24pin cable with 2 or 3 inch in diameter heatshrink.

Asa sad ta maka palit ug 2 or 3 inch na heatshrink? ganahan unta sad ko mag sleeve sa ako PSU

[blizzaga4]

@sir Blizzaga4
mau jud lage boss,Kerosene or WD40 ra ang makatangtang sa adhesive ani...ang gi-tape nako kay ang pheriperals cable man like 4-pin molex/sata power cables ...ang 24-pin kay as-is ra...tag-pila pud kaha ang per foot anang 2"diameter nga heatshrink tube sa?any idea?

You can find them at any electronics shop at colon. Try going to Cebu Advance and ACDC. They're even open on sundays. They cost less than 50 pesos.

[eldonex]

i bought mine sa loud and clear colon area, atbang na sa GV hotel. 2mm heat shrink tubes @ P8.00 per meter

[gaspar_73]

katong dagko ug diameter murag 5pesos kadak-on...pila pud kaha......

[eldonex]

la nakoy idea but cheap ghapon ang price ato tingali