##### sa tanan nga ganahan mo tweak sa ila canopy #######
here's a guide for you to override it so that you can change the settings again using the default IP
************************************************** ****************************
**I WILL NOT BE RESPOSIBLE FOR ANY DAMAGES THIS MAY CAUSE YOU. USE IT AS YOUR OWN RISK!**
************************************************** ****************************
This override plug resets the LAN 1 IP address to 169.254.1.1. The plug allows the operator to access the module through the default configuration without changing the configuration. The operator can then view and reset any non-default values.
Acquiring the Override Plug
To fabricate an override plug:
1. Install an RJ-11 6-pin connector onto a 6-inch length of CAT 5 cable.
2. Pin out all 6-pins.
3. Short (solder or twist together) Pins 4 and 6 on the other end. Do not connect any other wires to anything. The result should be as follows:
Pin 1 → white / orange ← Pin 1
Pin 2 → white / green ← Pin 2
Pin 3 → white / blue ← Pin 3
Pin 4 → green ← Pin 6
Pin 5 → blue ← Pin 5
Pin 6 → orange← Pin 4
here's how you should number your RJ-11 6-pin socket..
http://img.photobucket.com/albums/v2...akers/rj11.jpg
take note of the pins....save it pra dili ka makalimot.. hehehehe
http://3.bp.blogspot.com/_N92lyDXZbz...w/s1600/DP.jpg
pic of the actual jumper...
http://img.photobucket.com/albums/v2...s/DSCN0529.jpg
http://img.photobucket.com/albums/v2...s/DSCN0532.jpg
####this is where you connect the 4th and 6th pins or you design your own####
http://img.photobucket.com/albums/v2...s/DSCN0534.jpg
http://img.photobucket.com/albums/v2...s/DSCN0536.jpg
###########Using the Override Plug###########
The operator can regain access to the module as follows:
make sure you unplug the power supply of the module
1. Insert override plug into the RJ-11 GPS sync port of the module.
image:
http://i34.tinypic.com/3449xcp.jpg
2. Apply power to the module through the Ethernet cable.
RESULT: The module reboots with the default IP address of 169.254.1.1, password fields blank, and all other configuration values as previously set.
3. Set passwords as desired.
4. Change configuration values if desired.
5. Save the settings.
6. Remove the override plug.
7. Power cycle the module.